Abstract:Vibration response spectra measured from a broad range of heavy goods road vehicles were analysed to produce five response PDS (three for steel leaf suspension and two for air ride suspension) representative of rigid body response of road transport vehicles. It is recommended that these five representative spectra be used to synthesise more realistic vibrations should have a positive impact on the optimisation of packaging designs and a corresponding reduction in packaging waste. For decades, numerous attempts at re‐creating realistic (vertical) vibrations that purport to represent typical conditions during road transport have been proposed and published. This has and continues to result in a significant number of target power density spectra (PDS) for use in laboratory simulation of vibrations despite the fact that the underlying parameters that influence the vibrations (road surface unevenness and vehicle dynamics) remain largely unchanged. This paper seeks to address this situation by analysing published and measured PDS (129 in total) from a variety of vehicles and road types with the aim of establishing typical PDS. Through the analysis of the frequency of the first natural mode of these PDS, it was found that there exist five typical response PDS (three for steel leaf suspension and two for air ride suspension) that can be considered as representative vibration response PDS for road transport in general. These representative PDS were matched with a two degree‐of‐freedom quarter‐car model representing the heave response of the rigid body motion of the vehicles. The analysis suggests that the higher frequency content of the measured data is not related to rigid body motion but emanates from drivetrain and, in some cases, structural vibrations. These usually comprise numerous harmonics of fixed and varying frequencies as well as transients. As these vibrations are impossible to classify based on vehicle type, it is recommended that the five quarter‐car representative spectral models proposed in this paper—namely, for steel leaf spring suspended vehicles with heavy, moderate and light loads and air ride type vehicles with heavy and light loads—be used for laboratory simulation for the purpose of evaluating the vibration resistance of products and packaged systems. It is suggested that, for most packaged product, this is sufficient to test their ability to survive road transport vibrations. These will yield more realistic vibrations than those endorsed by standards organisations and should have a positive impact on the optimisation of packaging designs and a corresponding reduction in packaging waste. Finally, the need for further work aimed at developing methods to identify and extract fixed and varying discrete frequency vibration as well as transient vibrations was identified.

Limits of permissible vibrations of vehicles for different driving conditions and norms of vibration load

The Application of Sensitivity Method in Vehicle Dynamics Analysis

Environmental vibration induced by vehicle in complicated field

Road-friendliness of interconnected hydro-pneumatic suspension based on ADAMS/Simulink/AMESim

Characterisation of the Rigid Body Vibration Spectra of Road Transport Vehicles

Research on Vehicle Vibration Fatigue Damage Potential under Non-Gaussian Road Profile Excitation

Study of Ground Vibration from Trains Caused by Track Irregularities

Experimental Analysis of Passenger Comfort with Variable Preloaded Rear Springs on a Low-Cylinder Motorcycle

Optimal design of dynamic vibration absorber for elastic vibration control of vehicle carbody in time-varying service environment

Optimization and testing of suspension system of electric mini off-road vehicles

Difference thresholds for a vehicle on a 4-poster test rig

On vehicle response under non-Gaussian road profile excitation

Nonstationary time-frequency characteristics of vehicle suspension systems based on evolutionary power spectral density

Influence of Pavement Roughness on Riding Comfort Based on Whole Vehicle Model

Research on the Method of Whole Vehicle Load Spectrum Compilation Based on Road Surface irregularity

Passenger Car Vibration Dose Value Prediction Based on ISO 8608 Road Surface Profiles

Study of Suspension Parameters for Reduction of Road Damage Due to Dynamic Load

Subjective Discomfort Model of the Micro Commercial Vehicle Vibration over Different Road Conditions

Whole body vibration and rider comfort determination of an electric two-wheeler test rig

Human-bus-road coupled vibration considering effect of braking forces

Road safety: The influence of vibration frequency on driver drowsiness, reaction time, and driving performance