Abstract:Trucking is a key industry in Canada with around 180 000 professional drivers. As an industry it has a disproportionately high injury claim rate, particularly for back injuries. Whole-body vibration (WBV) can contribute to the onset and development of low back disorders, and is a well-documented exposure among driving professions. A widely adopted WBV mitigation measure focuses on hydraulic and/or pneumatic passive suspension systems both in the driver's seat and underneath the vehicle cab. Passive suspension 'air-ride' seats are the current industry standard but new technologies such as the electromagnetic active vibration cancelling (EAVC) seats offer potentially substantial improvements in WBV reduction. In this paper, we evaluate and compare four commonly used truck seats (three air-ride, one EAVC) for their vibration damping characteristics and WBV exposure attenuation in on- and off-road conditions. We recruited 24 professional truck drivers who drove 280 km (mixed on-road and off-road) in ore-haul trucks under four different seating conditions. Following the ISO 2631-1 WBV standard, vibration measurements were made on the cab floor and seat pad, and 8-h average weighted vibration (A(8)) and 8-h vibration dose values (VDV(8)) were calculated, as well as the Seat Effective Amplitude Transmissibility (SEAT), and daily vibration action limits (DVALs). These measures were compared between seat types, as well as road conditions. The EAVC seat gave best performance for both A(8) (0.27 m s-2) and VDV(8) (6.6 m s-1.75). The EVAC seat had the lowest SEAT tested (36.2%) and the longest DVAL. However, among the three passive air-suspension seats, two showed significantly reduced A(8) (0.43 and 0.44 m s-2) and VDV(8) (9.1 and 9.3 m s-1.75) exposures relative to the third passive air-suspension seats [A(8) (0.54 m s-2) and VDV(8) (11.1 m s-1.75)]. These differences in exposures among the three passive air-suspension seats resulted in varying DVAL times, with the worst performing seat reaching the DVAL after only 6.3 h of driving. There was also a seat by road type interaction; there were performance differences between the passive air-suspension seats on-road, but not off-road. The observed reduction of the WBV exposures measured from the EAVC seat was consistent with previous results. But we showed that there can also be substantive differences among seats that are the current industry standard. These differences were more evident on-road than off-road, which suggests that more work needs to be done to understand seat performance characteristics, and in matching the correct seat technology to the driving task. We demonstrated that WBV exposures in current industry conditions may exceed health-based exposure limits; this has policy relevance because WBV exposures are linked to prevalent and costly adverse health conditions in a working population that is ageing. Increased WBV measurement collection is recommended to ensure the anticipated exposure attenuations are achieved when seats are relied upon as an engineered control against WBV.

Passenger Car Vibration Dose Value Prediction Based on ISO 8608 Road Surface Profiles

Analysis of Stochastic Dynamic Pressure of Vehicle on Rough Pavement

Equivalent Vehicle Dynamic Load Coefficient on Rough Pavement

Difference thresholds for a vehicle on a 4-poster test rig

Characterisation of the Rigid Body Vibration Spectra of Road Transport Vehicles

Measurement and Analysis of Vibration Levels in Rail Transport in Central Europe

Virtual Accelerometer Approach to Create Vibration Profile for Automotive Component Shake Test

Simulation of a vehicle movement on a roadway with stochastic irregularities prescribed by the power spectral density

Influence of Pavement Roughness on Riding Comfort Based on Whole Vehicle Model

Limits of permissible vibrations of vehicles for different driving conditions and norms of vibration load

Assessment of passenger long-term vibration discomfort: a field study in high-speed train environments

Determination of Measurement Parameters for Vibration Analysis by Bus

Feasibility study on measurement of a physiological index value with an electrocardiogram tester to evaluate the pavement evenness and driving comfort

Evaluation of Ride Comfort in a Railway Passenger Car Depending on a Change of Suspension Parameters

Difference thresholds for primary and secondary ride of a vehicle on a 4-poster test rig

Analysis of vertical vibrations affecting a child transported in a child seat during a car passing over the release speed bump

Experiment and optimisation analysis of whole-body vibration among tractor drivers: a comprehensive study

Exposure to Whole-Body Vibration in Commercial Heavy-Truck Driving in On- and Off-Road Conditions: Effect of Seat Choice

Ride Comfort Analysis of Seated Occupants Based on an Integrated Vehicle-Human Dynamic Model

Modelling and ride comfort analysis of a coupled track-train-seat-human model with lateral, vertical and roll vibrations

Study on Vehicle Vibration Response under the Condition of 3D Tire–Pavement Contact for Unmanned Driving