Abstract:It has been widely considered that the global warming was induced by the increasing atmospheric concentrations of carbon dioxide, which has a significant impact on the sustainable development of the human society. Injecting carbon dioxide into depleted oil / gas reservoir has been developed to reduce carbon dioxide emission by the sequestration of CO2 underground, which is also considered as one promising approach to enhance oil recovery simultaneously. The evaluating of CO2 sequestration in oil reservoir needs highly accurate experimental data and models about the thermodynamic characters of CO2 + oil mixture. Density is one of key physical characters for simulating the diffusion and migration of carbon dioxide under the oil / gas reservoir. Research on volumetric behaviour is helpful to understand the expansion of the liquid phases in CO2 + oil mixture.In this paper, decane is investigated instead of petroleum because of the similar thermal physical property. The measurements have been performed at pressures from 12 MPa to 18 MPa and temperatures from 313.15 K to 343.15 K at four compositions x(1) (x(1) is the mole fraction of carbon dioxide) = 0.8690, 0.9135, 0.9430 and 0.9818 by a magnetic suspension balance (MSB). The accuracy of the experimental quantities presented in this work are T / K = +/- 0.01, m / g = +/- 10(-5) respectively. One circulation pump (AKICO, Japan) is equipped to accelerate the dissolution of CO2 in decane. Some conclusions can be obtained from the experiment as follow: (1) the dissolution of CO2 increases the density of decane, the density of CO2 + decane solution increases with increasing pressure and decreases with increasing temperature. (2) the slope of density with respect to pressure increases with increasing CO2 mole fractions while the slope with respect to temperature decreases with increasing CO2 mole fractions. (3) the crossover phenomenon appears at different compositions and the crossover pressure increases with temperature. (4) the excess molar volumes of this binary mixture are negative and show negative increasing with temperature for the data reported in this work. The GERG - 2008 model is used to predict density of CO2 + decane solution, which takes temperature, pressure, and CO2 concentration into account. An empirical equation is also used to predict the density of this binary mixture. The predictions show that the empirical equation is in good agreement with the experimental data over the experimental range. The measurement and the model used in this work supplies the basic experimental data and theoretical analysis to CO2 sequestration and enhance oil recovery. (C) 2013 The Authors. Published by Elsevier Ltd.

Liquid Viscosity and Density of Squalane and Squalane with Dissolved Carbon Dioxide at Temperatures From (298.15 to 548.15) K

Liquid viscosity, interfacial tension, thermal and mutual diffusivities of mixtures of n-eicosane with dissolved carbon dioxide

Diffusion Coefficients of L-Menthone and L-Carvone in Mixtures of Carbon Dioxide and Ethanol

Solubilities of Dodecylpolyoxyethylene Polyoxypropylene Ether in Supercritical Carbon Dioxide

Densities and Excess Volumes of CO2 + Decane Solution from 12 to 18mpa and 313.15 to 343.15K

Reference Correlations for the Density and Viscosity of Squalane from 273 to 473 K at Pressures to 200 MPa

Thermal Conductivity of Liquid Cyclohexane, n-Decane, n-Hexadecane, and Squalane at Atmospheric Pressure up to 353 K Determined with a Steady-State Parallel-Plate Instrument

Viscosity Measurements of Three Base Oils and One Fully Formulated Lubricant and New Viscosity Correlations for the Calibration Liquid Squalane

Measurement and Correlation of the Density, Viscosity and Vapor Pressure of Fatty Acid 2-Ethyhexyl Esters

Mixing Properties of Tris(2-ethylhexyl) Phosphate with Alkanes at Different Temperatures and Data Treatment Using Several Correlation Equations Based on Eyring's Absolute Reaction Theory

Simultaneous measurement of the density and viscosity for n-Decane + CO2 binary mixtures at temperature between (303.15 to 373.15) K and pressures up to 80 MPa

High Temperatures and High Pressures Brillouin Scattering Studies of Liquid H2O+CO2 Mixtures

Density and Volumetric Properties of Binary Mixtures of CO2 + Hexadecane from (303.2 to 473.2) K and Pressures Up to 50.0 MPa

Dynamic Viscosity and Interfacial Tension of CO2 and n-tetracosane System by Dynamic Light Scattering Method and Molecular Simulation

Integration of a fused silica capillary and in-situ Raman spectroscopy for investigating CO 2 solubility in n -dodecane at near-critical and supercritical conditions of CO 2

Molecular Simulation Study on the Density Behavior of n -Alkane/CO 2 Systems

(P, Ρ, T) Behavior of CO2 + Tetradecane Systems: Experiments and Thermodynamic Modeling

Measurement and Modeling of the Densities for Co2 + Dodecane System from 313.55 K to 353.55 K and Pressures Up to 18 Mpa

Speed of Sound Measurements for Liquid Squalane Up to a Pressure of 20 MPa

Experimental Study of Density, Viscosity and Equilibrium Carbon Dioxide Solubility in Some Aqueous Alkanolamine Solutions

Solubility study of carbon dioxide in pentaerythritol esters: Based on SAFT-VR-Mie equation of state