Abstract:Worldwide advance technologies, innovations and development in field of design and manufacturing have expended functionality of structures at small scale to fulfil requirement of behavior of material at micro level. Purpose behind this scope is to produce light weight structure by utilizing minimum material, cost and achieving maximum mechanical behavior of material. In order to achieve this approach, combination of experimental and numerical set up developed to focus on the effect of additive manufactured polymeric micro-lattice structures geometry over energy absorption capability, deformation and compression behavior. In this work, the energy absorption characteristics of three different polymeric lattice topologies i.e.uniform body centered cubic (UBCC), uniform body centered cubic reinforced in z- axis (UBCCz), and graded body centered cubic (GBCC) were considered, manufactured by using digit light processing (DLP) 3D printing technique. The quasistatic compression test was performed to study energy absorption capability, compression behavior, failure modes and relation between load and displacement. Although dimensions and mass of all polymeric lattice blocks were same but effect of cell architecture on mechanical behavior of lattice was significant. The mechanical behavior and deformationof GBCC is different from uniform counterparts. Densification rate in upper layers of GBCC having smaller diameter occurred earlier than next lower layer having larger diameter. Energy absorption capability in UBCCz is muchhigher than UBCC and GBCC. Large displacement deformation occurred in UBCC due to cell space. In UBCCz additional strut as reinforcement in z-direction acted as stress bearing member and improved its stress bearing capability. Moreover, higher elastic modulus and stiffnessin UBCCzis observed than other two cell topologies. In the end, finite element simulations were carried out using LS DYNA-3D to validate the result and comparing it with experimental data.

Quasi-static and dynamic compressive behaviour of additively manufactured Menger fractal cube structures

Energy absorption and mechanical performance of 3D printed Menger fractal structures

Low-velocity impact response and energy absorption of Menger sponge-inspired fractal structures fabricated by selective laser melting

Quasi-static Compressive Behaviors of Large-Size Titanium Lattice Sandwich Structure Based on Pulse Hot-Wire Arc Additive Manufacturing

Mechanical performance of fractal-like cementitious lightweight cellular structures: Numerical investigations

On the feasibility and the impact resistance of a 3D cross-based fractal produced by powder bed fusion additive manufacturing

Energy absorption and compression behaviour of polymeric 3D printed lattice structures - experimental and numerical study

3 D In-situ XCT Image Based Mesoscale Fracture Modelling and Validation of Concrete Using Voxel Hexahedron Meshing and Damage Plasticity Model

Crashworthiness capability comparison of a 3D Greek cross fractal structure additively manufactured with polyamide and thermoplastic polyurethane

Compressive mechanical behavior of additively manufactured 3D auxetic metamaterials with enhanced strength

Dynamic Fracture and Dissipation Behaviors of Concrete at the Mesoscale

Experimental and numerical investigation of 3D printed micro-lattice structures for high energy absorption capabilities

Compression and resilient behavior of graded triply periodic minimal surface structures with soft materials fabricated by fused filament fabrication

Compression Experiment and Failure Analysis of Additive Manufactured Multi-Layer Lattice Sandwich Structure

On crashworthiness behaviors of 3D printed multi-cell filled thin-walled structures

Effect of varying core density and material on the quasi‐static behaviors of sandwich structure with 3D‐printed hexagonal honeycomb core

Superior compressive properties of 3D printed plate lattice mechanical metamaterials

Flexural properties of additively manufactured structures reinforced with cellular and fractal patterns.

An Experimental and Numerical Investigation into Compressive Failure of Pyramidal Lattice Sandwich Structures Fabricated Using Stereolithography Technology

Experimental studies on quasi-static axial crushing of additively-manufactured PLA random honeycomb-filled double circular tubes

Comparative performance evaluation of microarchitected lattices processed via SLS, MJ, and DLP 3D printing methods: Experimental investigation and modelling