Abstract:Chemical looping gasification (CLG) is considered as a novel gasification technology because gas-phase oxygen of the gasifying medium can be replaced by lattice oxygen of the oxygen carrier. The gasifying mediums (e.g., pure O-2 and steam) used as the oxygen source can apparently improve the char conversion in traditionally biomass gasification. Similarly, the objective of this study is to investigate char CLG with the oxygen carrier as an individual oxygen source. A NiO-modified iron ore oxygen carrier was prepared by the impregnation method coupled with ultrasonic treatment. The characteristics of the oxygen carrier were analyzed by an X-ray diffractometer (XRD) and H-2 temperature-programmed reduction (H-2-TPR). The formation of spinel-type nickel iron oxide NiFe2O4 can evidently enhance the reactivity of the oxygen carrier. The reduction of the oxygen carrier by biomass char was investigated using thermogravimetric analysis (TGA) together with a fixed-bed reactor under an inert atmosphere. TGA tests show that the reactivity of the oxygen carrier increased with the increase of NiO loading. An optimal mass ratio of char/oxygen carrier is determined at 4:6 With the aim of obtaining a maximum reaction rate. The presence of spinel-type nickel iron oxide NiFe2O4 apparently improved the reaction rate of char gasification. The fixed-bed gasification results show that CO was generated faster than other components because carbon was partially oxidized and H-2 was quickly consumed by the lattice oxygen [O] of the oxygen carrier. A relatively high carbon conversion of 55.56% was obtained in the char CLG, in comparison to that of char pyrolysis (5.52%). The lattice oxygen [O] of the oxygen carrier was fully consumed by biomass char. Moreover, biomass char was catalytically, pyrolyzed becausee the deep reduction products (metallic iron and nickel) can act as catalysts for char pyrolysis. XRD analysis shows that the oxygen carrier was deeply reduced into Fe (Ni) alloy and Fe3C species during the reduction stage of Char CLG. However, the. regenerated oxygen carrier after oxidation can be recycled for char CLG on the basis of XRD and scanning electron microscopy (SEM) analyses.

Thermodynamic analysis of syngas generation from biomass using chemical looping gasification method

Chemical looping pyrolysis-gasification of biomass for high H2/CO syngas production

Thermodynamic Analysis of the Biomass-To-Synthetic Natural Gas Using Chemical Looping Technology with Cao Sorbent

Syngas, tar and char behavior in chemical looping gasification of sawdust pellet in fluidized bed

Thermodynamic Evaluation of Sorption-Enhanced Chemical Looping Gasification with Coal As Fuel

Chemical Looping Gasification of a Biomass Pellet with a Manganese Ore as an Oxygen Carrier in the Fluidized Bed

Thermodynamic Analysis and Thermogravimetric Investigation on Chemical Looping Gasification of Biomass Char under Different Atmospheres with Fe2O3 Oxygen Carrier

Reactivity Investigation on Biomass Chemical Looping Conversion for Syngas Production

Syngas Production by Chemical Looping Gasification of Biomass with Steam and CaO Additive

Syngas Production by Chemical Looping Gasification Using Fe Supported on Phosphogypsum Compound Oxygen Carrier

Chemical Looping Gasification of Biomass Char Using Iron Ore As an Oxygen Carrier

Thermodynamic analysis and kinetic investigations on biomass char chemical looping gasification using Fe-Ni bimetallic oxygen carrier

Syngas Production by Chemical Looping Co-Gasification of Rice Husk and Coal Using an Iron-Based Oxygen Carrier

Microwave-assisted Chemical Looping Gasification of Sugarcane Bagasse Biomass Using Fe3O4 As Oxygen Carrier for H2/CO-rich Syngas Production

Chemical looping deoxygenated gasification: An implication for efficient biomass utilization with high-quality syngas modulation and CO<sub>2</sub> reduction

Liquid Chemical Looping Gasification of Biomass: Thermodynamic Analysis on Cellulose

Syngas Production by Biomass Chemical Looping Gasification with Composite Oxygen Carrier of Fe/Ce Mixed Phosphogypsum

Chemical Thermodynamics Analysis for In-Situ Gasification Chemical Looping Combustion of Lignite with Phosphogypsum for Syngas

Numerical Investigation of Chemical Looping Gasification Process Using Solid Fuels for Syngas Production

Chemical Looping Gasification of Biomass for High H2/CO-Ratio Syngas

The Crucial Role of Deoxygenation in Syngas Refinement and Carbon Dioxide Utilization During Chemical Looping-Based Biomass Gasification