Abstract:More than one million tons of secondary aluminum dross as a hazardous waste are produced by aluminum manufacturers per year throughout the world, which imposes high disposal costs and serious environmental problems. As secondary aluminum dross is considered as an alumina-rich inorganic waste, this study aims to propose a promising approach for clean production of activated-alumina as a widely-used adsorbent, catalyst and catalyst support. In this paper, synthesis and characterization of high crystalline activated-alumina nanopowder from secondary aluminum dross using a novel five-step leaching-based process are presented. To optimize the process, various parameters of dross particle size, leaching time, leaching temperature, acid concentration, and liquid-to-solid ratio were studied using One-Factor-At-a Time approach (OFAT). For the following optimum leaching conditions: particle sizes between 38 and 75 μm, leaching time of 120 min, leaching temperature of 85 °C, acid concentration of 5 M, and the liquid-to-solid ratio of 20 ml/g, the extraction efficiency of alumina was around 83%. The leach liquor was purified by adding 2 N NaOH resulting in sodium aluminate-rich solution. The purified liquor was treated by adding HCl to precipitate Al(OH)3, and the Al(OH)3 was then washed and calcined at 700 °C for 2 h to obtain alumina. Chemical composition, mineralogical phases, chemical bonds, morphology, and particle size distribution of the as-synthesized activated-alumina were determined using X-ray fluorescence (XRF), X-ray diffractometry (XRD), Fourier transform infrared (FTIR) spectroscopy, field emission scanning electron microscopy (FESEM), and dynamic light scattering (DLS), respectively. The as-synthesized activated-alumina exhibited 97.61% purity. Its XRD pattern showed mainly characteristic peaks of gamma phase of alumina. Morphological study by FESEM revealed that the as-synthesized alumina particles have rounded-corner shape. The crystal and average particle size values were about 18.47 and 513 nm, respectively.

Research in the Area of Preparing Activated Alumina. Part 5. Different Technological Approaches to the Process of Fine Milling of High-Alumina Raw Materials

Research in the Field of Obtaining Activated Alumina. Part 6. Effect of Complex Additive on Reactive Alumina Production Technology and Properties of Alumina Based Low-Cement Refractory Castables

Formation and Control of Agglomerates in Alumina Powder

A promising green process for synthesis of high purity activated-alumina nanopowder from secondary aluminum dross

Improvement in dispersion stability of alumina suspensions and corresponding chemical mechanical polishing performance

Preparation of Composite Spherical Alumina Nanoparticles and Study on their CMP Performance

High concentration of organic solvents in aluminum MAO: A study of structural and tribological property

Preparation and research of fine-grained alumina with high mechanical properties

Examination of patterns in obtaining porous structures from submicron aluminum oxide powder and its mixtures

Analysis Of Alumina Particles Size And Shape Formation From Developed Planetary Ball Mill

Preparation of Porous Alumina Abrasives with Different Morphologies and their Chemical Mechanical Polishing Behavior

Alumina ceramics prepared with new pore-forming agents

The Peculiar Properties of Economically Effective Technology of Forming of the Ceramic Coating Based on Aluminum Oxide

Synthesis of submicronic α-alumina from local aluminum slags

High-performance chemical mechanical polishing slurry for aluminum alloy using hybrid abrasives of zirconium phosphate and alumina

Removal of Aluminosilicate Bond and Process Optimization on Recovery of Sol Gel Alumina Abrasive Grain from Abrasive Industry Waste

Self-Lubricating PEO Coating on an Al Alloy Produced by Vacuum Impregnation Post-treatment

Technology for High Pure Aluminum Oxide Production from Aluminum Scrap

PVB/PEG-Based Feedstocks for Injection Molding of Alumina Microreactor Components