Abstract:The co‐design of power amplifiers (PA) and filter. PAs are often followed by filters to provide the out‐of‐band rejection and thus improve the signal‐to‐noise ratio. However, due to the limitation on the antenna element spacing, this configuration is too large in system and the interconnections have a high insertion loss. So, integrating the functionality of filtering response into the PAs is a more compact and lower loss scheme. Summary In this paper, an out‐of‐band suppression enhanced high‐efficiency millimeter‐wave (mm‐wave) gallium nitride (GaN) microwave monolithic integrated circuit (MMIC) filtering power amplifier (FPA) is presented. A modified elliptic response bandpass filtering (BPF) output matching network (OMN) is used to achieve low loss and high out‐of‐band rejection. The circuit of the presented BPF OMN is given and its synthesized method is introduced. The simulated S‐parameters show that the OMN has a low‐loss in‐band response and a desired out‐of‐band rejection performance with two transmission zeros (TZs). To demonstrate this idea, a two‐stage 24–28‐GHz GaN MMIC PA is designed and implemented in a 0.15‐μm GaN‐on‐SiC process, with a mask area of 2.4 × 1.0 mm2. Experimental results show that the realized MMIC PA achieves a small signal gain of 18.8 dB from 24 to 28 GHz with ±1.2‐dB gain flatness and 40‐dB rejection at 19.43 and 33.8 GHz. The saturated power‐added efficiency (PAE) is higher than 29% from 24 to 28 GHz, with a peak PAE of 36.3% at 27 GHz. The output power is within the range of 33.8 to 35.6 dBm in the operating band. For a 100‐MHz five‐carrier LTE signal, the PA can achieve ACLR better than −40 dBc over the band with digital predistortion.

Design of broadband high-efficiency power amplifier based on elliptic low-pass and band-pass matching network

A Broadband High-Efficiency Quasi Class E Internally-matched GaN Power Amplifier with a Compact Band-Pass Output Matching Structure

Design of X/Ku Dual-Wideband GaN Power Amplifier MMIC Based on Coupled Multiresonator Matching Networks

X-Band High-Efficiency Continuous Class B Power Amplifier Gan Mmic Assisted By Input Second-Harmonic Tuning

Asymmetric Doherty Power Amplifier with Input Phase/Power Adjustment and Envelope Tracking

Design and Analysis of a 26–34.5-Ghz Power Amplifier with Balanced Mismatch Reduction and Interstage Matching

Design of a broadband high-efficiency power amplifier based on ring-resonant filter with compensation architecture and a series of continuous modes

Class F and Inverse Class F Dual Modes Dual Bands Power Amplifier

Broadband class E GaN power amplifier design in S band with low-pass match

Novel Design Space of Broadband High-Efficiency Parallel-Circuit Class-EF Power Amplifiers

A Novel Impedance Matching Network Suitable for Designing High-Efficiency Power Amplifiers.

Design of a Series of Inverse Continuous Modes Power Amplifier Based on Bandpass Filter

High efficiency GaN power amplifier with compact harmonic tuning network

Highly Efficient Broadband Continuous Inverse Class-F Power Amplifier Design Using Modified Elliptic Low-Pass Filtering Matching Network

Broadband and Highly Efficient Class-J Power Amplifier with Compact Output Matching Network

A Broadband Microwave GaN HEMTs Class EF3 Power Amplifier with Π-Type Network

Design of Broadband Highly Efficient Power Amplifier Based on Low‐Pass Filtering Network With Periodic Structure

High‐efficiency broadband power amplifier design via ideal de‐embedding and direct compensation of GaN‐HEMTs parasitics

Modified elliptic response bandpass filtering integrated high‐efficiency GaN MMIC power amplifier at 24–28 GHz

Systematic Design Methodology of Broadband Doherty Amplifier Using Unified Matching/Combining Networks With an Application to GaN MMIC Design

Design of a broadband high‐efficiency extended resistive continuous Class‐B/J power amplifier with novel drain voltage waveforms