Abstract:Supported V2O5–WO3/TiO2 materials are employed as selective catalytic reduction (SCR) catalysts for NOx emission control from power plants. Fresh SCR catalysts usually receive exposure to harsh treatments in the industry to accelerate catalyst activation (calcination in air at 650 °C) and catalyst aging (hydrothermal aging at 650 °C) in a way that represents various points in the catalyst/product lifetime. The present study investigates the catalyst structural and chemical changes occurring during such harsh treatments. Three series of supported V2O5–WO3/TiO2 catalysts were prepared by incipient-wetness impregnation of aqueous ammonium metavanadate and metatungstate precursors. The catalysts were subsequently dried and calcined at 550 °C in O2, 650 °C in O2, and hydrothermal conditions (10% O2, 8% H2O, 7% CO2, and 75% N2) at 650 °C. The resulting catalysts were physically characterized by numerous techniques (in situ Raman; in situ IR; in situ high-field–high-spinning solid-state 51V MAS NMR; in situ electron paramagnetic resonance; X-ray diffraction; Brunauer, Emmett, and Teller surface area; and inductively coupled plasma) and chemically probed with adsorbed ammonia, SCR–TPSR, and the SCR reaction. The surface WOx sites on the TiO2 support behave as a textural promoter that stabilizes the TiO2 (anatase) phase from sintering and transforming to the undesirable crystalline TiO2 (rutile) phase that can lead to formation of a Ti1–xVxO2 (rutile) solid solution with reduced V4+ cations (∼7–15%). The surface VOx sites are mostly oligomerized as surface V5+Ox sites (∼50–85% oligomers) and the extent of oligomerization tends to increase with surface WOx coverage and calcination temperature. A major difference between the calcined and hydrothermally treated catalysts was the low concentration of surface NH3* species on Lewis acid sites for the hydrothermally treated catalysts, yet the SCR activity was almost comparable for both catalysts. This finding suggests that surface NH4+*, primarily associated with the surface VOx sites, are able to efficiently perform the SCR reaction. Given that multiple catalyst parameters were simultaneously varying during these treatments, it was difficult to correlate the SCR activity with any single catalyst parameter. A correlation, however, was found between the SCR TOF/activity and the sum of the surface NH3* and NH4+* species, which is dominated by the surface NH4+* species.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acscatal.1c02130.ICP of vanadium content of catalysts; crystallite sizes for supported VWTi catalysts treated at 650 °C; EPR determination of V4+; solid-state 51V MAS NMR spectra of dehydrated supported V2O5–WO3/TiO2 catalysts calcined at 650 °C; EPR spectra of non-vanadium species; in situ TP-IR spectra of surface ammonia species during SCR; correlation plots between steady-state SCR TOF values and structural properties of VWTi catalysts; and radar plots of catalytic activity and catalyst properties (PDF)This article has not yet been cited by other publications.

Structure-Directing Role of Support on Hg 0 Oxidation over V 2 O 5 /TiO 2 Catalyst Revealed for NO x and Hg 0 Simultaneous Control in an SCR Reactor

Structure-Directing Role of Support on Hg0 Oxidation over V2O5/TiO2 Catalyst Revealed for NOx and Hg0 Simultaneous Control in an SCR Reactor.

The Effect of Cr Addition on Hg0 Oxidation and NO Reduction over V2O5/TiO2 Catalyst

Vanadium-density-dependent reactivity for simultaneous removal of NOx and Hg0 over V2O5/TiO2 catalyst

Structure-Directing Role of Support on Toluene Catalytic Combustion over Pt/TiO2 Catalysts

Influence of texture structures of TiO2 supports on surface properties and SCR performance of V2 O5-MoO3/TiO2 catalyst

The Progress of V<sub>2</sub>O<sub>5</sub>/TiO<sub>2</sub>-Based Catalyst in Hg<sup>0</sup> Removal and PCCD/Fs Decomposition

Sn-doped Rutile TiO2 for Vanadyl Catalysts: Improvements on Activity and Stability in SCR Reaction

Promotion Effect of Tungsten Oxide on SCR of NO with NH3 for the V2O5–WO3/Ti0.5Sn0.5O2 Catalyst: Experiments Combined with DFT Calculations

Interface sites on vanadia-based catalysts are highly active for NOx removal under realistic conditions

Exploring the Role of V2O5 in the Reactivity of NH4HSO4 with NO on V2O5/TiO2 SCR Catalysts

Structure–Activity Relationships of Hydrothermally Aged Titania-Supported Vanadium–Tungsten Oxide Catalysts for SCR of NO x Emissions with NH 3

Uncovering the Dinuclear Mechanism of NO 2 -Involved NH 3 -SCR over Supported V 2 O 5 /TiO 2 Catalysts

Investigations of Surface VOx Species and Their Contributions to Activities of VOx/Ti0.5Sn0.5O2 Catalysts Toward Selective Catalytic Reduction of NO by NH3

Effect of Dispersion State and Surface Properties of Supported Vanadia on the Activity of V2O5/TiO2 Catalysts for the Selective Catalytic Reduction of NO by NH3

New Insights into the Promotional Effects of Cu and Fe over V2O5-WO3/TiO2 NH3-SCR Catalysts Towards Oxidation of Hg0

Catalytic oxidation of CO over V2O5/TiO2 and V2O5-WO3/TiO2 catalysts: A DFT study

Exploring the role of V<sub>2</sub>O<sub>5</sub> in the reactivity of NH<sub>4</sub>HSO<sub>4</sub> with NO on V<sub>2</sub>O<sub>5</sub>/TiO<sub>2</sub> SCR catalysts

Crystal Orientation-Dependent Activity of Tungsten-Based Catalysts for Selective Catalytic Reduction of NOx with NH3

Enhancing the activity and sulfur resistance of CuFeAlO x catalyst via the structure effect for the simultaneous removal of Hg 0 and NO at wide temperature

Crystal-Plane-Engineered TiO2-Anchored Vanadium Single Atoms and Clusters for Boosting Ultradeep Aerobic Oxidative Desulfurization of Diesel