Abstract:V 2 O 5 -WO 3 /TiO 2 (VWTi) catalyst has long been utilized in fixed source flue gases to purify harmful NO gas. However, VWTi is classified as a hazardous material because of its harm to human health and environment. To address this issue, a low-cost green Cu-based zeolite catalyst (Cu@13X) with a wide temperature range was synthesized using an in-situ hydrothermal method. This method is intended to control the adsorption capacity of toxic SO 2 by regulating the location of Cu species. UV-Vis DRS and EXAFS analyses revealed that a significant amount of Cu was encapsulated within the 12-membered ring pores of the 13X molecular sieve. SO 2 -TPD and DFT calculations further indicated that Cu@ 13X exhibits reduced SO 2 chemical adsorption capacity. Consequently, this green catalyst demonstrated superior catalytic performance, maintaining superior NO x conversion for over 70 h in the mixture gas containing 250 ppm SO 2 ; while the Cu/13X catalyst lacked NH 3 -SCR catalytic activity under the same conditions. Moreover, Cu@ 13X catalyst also has excellent NH 3 -SCR catalytic performance in low temperature flue gas below 250 °C, which is significantly better than the hazardous VWTi catalyst. Characterization techniques such as NH 3 -TPD, H 2 -TPR, and XPS confirmed that the Cu@ 13X catalyst possesses excellent acidity, robust redox capabilities, and abundant surface defects. In-situ DRIFT spectra further illustrated that the NH 3 -SCR reaction on the catalyst surface adheres to the Eley-Rideal mechanism both before and after the introduction of toxic SO 2 . This study offers a fresh perspective on the development of framework-confined NH 3 -SCR catalysts and elucidates the mechanism behind the sulfur resistance of these catalysts. And the green Cu@ 13X catalyst is anticipated to serve as an effective alternative to the hazardous VWTi catalyst.

Enhancing the activity and sulfur resistance of CuFeAlO x catalyst via the structure effect for the simultaneous removal of Hg 0 and NO at wide temperature

Mechanistic Study on the Enhanced SO2-tolerant Ability of CuCl2-promoted MnOx-CeOx Mixed Oxide for Hg0 Removal

Enhanced SO2 Tolerance of FeCeOx/CNTs Catalyst for NO and Hg0 Removal by Coating Shell SiO2

Construction of multifunctional interface engineering on Cu-SSZ-13@Ce-MnOx/Mesoporous-silica catalyst for boosting activity, SO2 tolerance and hydrothermal stability

Porous Fe-modified CuCeZr catalysts for simultaneous removal of NO and toluene at low-medium temperatures: Promoted activity and SO2 effect on the reaction process

Modulating the Activity and SO 2 Resistance of α-Fe 2 O 3 Catalysts for NH 3 -SCR of NO x via Crystal Facet Engineering

A Sulfur-Tolerant MOF-Based Single-Atom Fe Catalyst for Efficient Oxidation of NO and Hg0

A facile MnSO4 surface coated NiMnFeOx catalyst with enhanced SO2 resistance for SCR reaction: A dual-protection mechanism

The facilitating effect of sulfide treatment coupled sol-gel method on NH 3 -SCR activity of Fe–Mn/TiO 2 catalysts

Enhanced H2S Removal Efficiency Using CuO/Al2O3 Catalyst Impregnated with Ca(NO3)2: Influence of Calcination Temperature and Mechanistic Insights

Atomic layer deposition of silica to improve the high-temperature hydrothermal stability of Cu-SSZ-13 for NH3 SCR of NOx

Boosting SO2-Resistant NOx Reduction by Modulating Electronic Interaction of Short-Range Fe-O Coordination over Fe2O3/TiO2 Catalysts

Mechanistic Investigation of the Enhanced SO2 Resistance of Co-modified MnOx Catalyst for the Selective Catalytic Reduction of NOx by NH3

Engineering CeZrOx-Cu/SSZ-13 coupled catalysts to synergistically enhance the low-temperature NH3-SCR activity

Novel framework-confined Cu@ 13X catalyst with excellent resistance to toxic SO 2 as an eco-friendly substitute for hazardous V-based NH 3 -SCR catalyst

Insights into the highly activity CuMgFe oxides for the selective catalytic reduction of NO by CO: Structure-activity relationships and K/SO2 poisoning mechanism

Ti species regulated CuO/CeO2 catalyst for efficient simultaneously NH3-SCR denitration and CO oxidation under oxygen-rich conditions

Low-Cost CuX Catalyst from Blast Furnace Slag Waste for Low-Temperature NH 3 -SCR: Nature of Cu Active Sites and Influence of SO 2 /H 2 O

Alkali- and Sulfur-Resistant Tungsten-Based Catalysts for NOx Emissions Control.

The Role of the Cu Dopant on a Mn3O4 Spinel SCR Catalyst: Improvement of Low-Temperature Activity and Sulfur Resistance

Interface Induced by Hydrothermal Aging Boosts the Low-Temperature Activity of Cu-SSZ-13 for Selective Catalytic Reduction of NOx