Abstract:This paper addresses the acoustic and aerodynamic characteristics of small rotor configurations, including the influence of the rotor–rotor interactions. For this purpose, a Rotor/Rotor/Pylon configuration is chosen for both the test and numerical simulations. The wind tunnel experiments on various rotor configuration were performed in DLR's Acoustic Wind Tunnel Braunschweig (AWB). The experiments involve isolated rotors, and rotors in tandem and coaxial configuration in hover and forward flight. For numerical simulations, an unsteady free wake 3D panel method (UPM) is used to account for aerodynamic non-linear effects associated with the mutual interference among the Rotor/Rotor/Pylon configurations. The effect of the pylon is simulated using potential theory in form of a panelized body. Finally, the sound propagation into the far field is calculated with DLR's FW–H code APSIM, using UPM blade surface pressure as input. The validation effort is supported by CFD TAU steady simulations on selected hover test cases. The experiments and numerical results indicate that the noise at the blade passing frequency (BPF) and its higher harmonics is the dominant source of the noise for the present rotor selection. The extra subharmonics between two BPFs appearing in the results are caused by the small geometric discrepancy between the blades as well as the motor noise. Broadband noise is also observed in the experiment, but its contribution to the overall sound pressure is very small and can be neglected. The simulation of the acoustic scattering from the rotor support system for the isolated rotor cases indicated an influence about 1–3 dB on the overall sound pressure of the polar microphones. In both the coaxial and the tandem configuration, the acoustic interferences are particularly well visible in the numerical simulations and cause a more complex noise directivity. There is almost no change in time-averaged inflow by applying phase angles. In the coaxial condition, in hover, the phase delay between rotors does not change the maximum noise level. In forward flight, the phase delay can influence the maximum level of the noise radiation. In both coaxial and tandem configuration, the position of the downstream rotor is key for the noise radiation, and therefore, avoiding the interaction with upstream wake can reduce the noise radiation.

Research on near field aeroacoustics suppression of tilt-rotor aircraft based on rotor phase control

Tilt-rotor aircraft fuselage wall aeroacoustics radiation suppression using Higher harmonic control

A global rotor noise control method based on near-field acoustic holography and sound field reproduction

Numerical analyses of aeroacoustic characteristics of tiltrotor considering the aerodynamic interaction by the fuselage in hover

Experimental Study to Quantify the Rotor-to-Rotor Interaction Characteristics of a Small Unmanned-Aerial-Vehicle

An Experimental Study on Rotor Aerodynamic Noise Control Based on Active Flap Control

Noise attenuation of frequency-modulated multi-rotor using sound field reproduction

Aeroacoustic and aerodynamic measurements at the rotor plane in the interaction of a small rotor with wings

A Dynamic RCS and Noise Prediction and Reduction Method of Coaxial Tilt-Rotor Aircraft Based on Phase Modulation

Noise attenuation of quadrotor using phase synchronization method

Experimental study on noise reduction of multi-rotor by phase synchronization

Experimental study on noise reduction of a wavy multi-copter rotor

Assessment and Mitigation of the Rotor Noise for Future Urban Air Mobility Vehicles

Acoustic Mechanisms and Tonal Noise Control of Contra-Rotating Ducted Fan by Rotating Speed Regulation

Aerodynamic and Aeroacoustic Optimization of UAV Rotor Based on Proper Orthogonal Decomposition Method

Experimental Investigation of Ducted Fan Noise Control by Turbulence Grids Insertion Between Propellers and Struts

A Computational Aeroacoustic Study of a Multi-Rotor Powered Urban Air Mobility Vehicle

Numerical study of acoustic source localization of rotor using a novel discrete noise analysis strategy

Impact of Rotor-to-Rotor Interactions on the Tonal Noise Characteristics of Different Octocopter Configurations

A minimum objective function trim procedure for VTOLs noise reduction

Numerical studies on small rotor configurations with validation using acoustic wind tunnel data