Abstract:The contra-rotating ducted fan (CRDF) involves more tonal noise modes compared with rotor/stator and singlerotor ducted fans. According to the present experiment on small-scale CRDF the dominant tone is concentrated at the harmonics of blade passing frequencies of front-rotor and rear-rotor as the modes of (m,0) and (0,n), as well as the modes (m,m) respectively. To investigate the flow mechanisms and sound propagation characteristics of these three types of tonal noise, unsteady three-dimensional numerical simulation was implemented under different rotational speed matching for CRDF and isolated rotor. Steady load and thickness noise were systematically analyzed using Hanson model. And the generation mechanisms of wake interaction noise and their contribution ratios were analyzed utilizing the duct sound model. It was indicated that tonal noise at the mode of (m,0) (0,n) of CRDF is primarily determined by the blade thickness and steady load. Compared with the single-rotor, the contra-rotating rotors could improve the load allocation between the front and rear rotor, resulting in the forward noise reduction with the constant thrust. Increasing the rear rotor speed enhances the contribution of potential flow interaction noise from the front rotor. Subsequently the front rotor load and wake interference are weakened, leading to noise reduction of approximately 0.3 dB for the rear rotor. However, the potential flow disturbance is intensified which causes noise increase by approximately 3.5 dB on the front rotor. But, increasing the front rotor speed will strengthen both the potential flow interference intensity on the pressure surface of the front rotor blade and the wake disturbance intensity on the leading edge of the rear rotor blade. This generates approximately 3 dB and 3.5 dB noise level increases for the front and rear rotors, respectively. As a result, appropriately raising the rear rotor speed can achieve a reasonable load allocation, and balance the potential flow interaction and wake interaction to realize the whole noise reduction without thrust loss.

Noise attenuation of frequency-modulated multi-rotor using sound field reproduction

Noise attenuation of quadrotor using phase synchronization method

A global rotor noise control method based on near-field acoustic holography and sound field reproduction

Fast prediction method for multirotor global tonal noise based on acoustic modal analysis

An Investigation of Multi-rotor Drone Noise Based on the Acoustic Hemisphere in an Actual Environment

Motor Noise Reduction of Unmanned Aerial Vehicles

Experimental Investigation on Motor Noise Reduction of Unmanned Aerial Vehicles

Experimental study on noise reduction of multi-rotor by phase synchronization

A Computational Aeroacoustic Study of a Multi-Rotor Powered Urban Air Mobility Vehicle

Experimental Study to Quantify the Rotor-to-Rotor Interaction Characteristics of a Small Unmanned-Aerial-Vehicle

Research on near field aeroacoustics suppression of tilt-rotor aircraft based on rotor phase control

Experimental study on noise reduction of a wavy multi-copter rotor

Active Noise Control Experiment for Unmanned Aerial Vehicle Propeller

High-efficiency prediction method for helicopter global/ground noise based on near-field acoustic holography

Assessment and Mitigation of the Rotor Noise for Future Urban Air Mobility Vehicles

An Experimental Study on Rotor Aerodynamic Noise Control Based on Active Flap Control

Global prediction and analysis for helicopter noise footprint based on acoustic modes

Characterization of multi-rotor aircraft using truss support structure

Acoustic Mechanisms and Tonal Noise Control of Contra-Rotating Ducted Fan by Rotating Speed Regulation

Noise measurement of a quadrotor drone in an anechoic chamber

Tilt-rotor aircraft fuselage wall aeroacoustics radiation suppression using Higher harmonic control