Abstract:Laboratory modeling of in-situ combustion is crucial for understanding the potential success of field trials in thermal enhanced oil recovery and is a vital precursor to scaling the technology for field applications. The high combustion temperatures, reaching up to 480°C, induce significant petrophysical alterations of the rock, an often overlooked aspect in thermal EOR projects. Quantifying these changes is essential for potentially repurposing thermally treated, depleted reservoirs for CO 2 storage. In this study, we depart from conventional combustion experiments that use crushed core, opting instead to analyze the thermal effects on reservoir properties of carbonate rocks using consolidated samples. This technique maintains the intrinsic porosity and permeability, revealing combustion's impact on porosity and mineralogical alterations, with a comparative analysis of these properties pre- and post-combustion. We characterize porosity and pore geometry evolution using low-field nuclear magnetic resonance, X-ray micro-computed tomography, and low-temperature nitrogen adsorption. Mineral composition of the rock and grain-pore scale alterations are analyzed by scanning electron microscopy and X-ray diffraction. The analysis shows a significant increase in carbonate rocks' porosity, pore size and mineral alterations, and a transition from mixed-wet to a strongly water-wet state. Total porosity of rock samples increased in average for 15%–20%, and formation of new pores is registered at the scale of 1–30 μm size. High-temperature exposure results in the calcite and dolomite decomposition, calcite dissolution and formation of new minerals – anhydrite and fluorite. Increased microporosity and the shift to strongly water-wet rock state improve the prospects for capillary and residual CO 2 trapping with greater capacity. Consequently, these findings highlight the importance of laboratory in-situ combustion modeling on consolidated rock over tests that use crushed core, and indicate that depleted combustion stimulated reservoirs may prove to be viable candidates for CO 2 storage.

Thermal behavior of aluminothermic thermite reaction for application in thermal sealing of oil wells

Experimental investigation of AL-Fe2O3 thermite reactions for thermal plug and abandonment of oil wells

NUMERICAL SOLUTION OF COUPLED HEAT TRANSFER WITH PHASE-CHANGE AND THERMITE REACTION

Control Model and Optimization Study of Temperature Distribution Applied in Thermite Plugging and Abandonment Technology

Mass and Heat Transfer of Thermochemical Fluids in a Fractured Porous Medium

Corrosion-Resistant Plug Materials for Geothermal Well Fluid Control

Analysis of the Aluminothermic Reaction Process

A Novel Method of Removing Emulsion Blockage after Drilling Operations Using Thermochemical Fluid

Thermal-chemical Reaction Characteristics of Ni/Al2O3 Catalytic Porous Material Filled Solar Reactor for Dry Reforming of Methane Process

Influence of Cro3 Additive on the Thermite Reaction Procedure in Fe2o3+Al System

Thermal performance of Cu/Al micron-nanometer composites with tungsten trioxide

High speed 2-dimensional temperature measurements of nanothermite composites: Probing thermal vs. Gas generation effects

Synthesis of Fe2O3/Al Nanocomposite and Research on Its Thermite Reaction

Fabrication and Characterization of Highly Porous FeAl-Based Intermetallics by Thermal Explosion Reaction

Elucidating the dominant mechanisms in burn rate increase of thermite nanolaminates incorporating nanoparticle inclusions

Study on Thermal Chemical Reaction of Al/MnO2 Thermite

Mechanism for thermite reactions of aluminum/iron-oxide nanocomposites based on residue analysis

Thermite reactions of Al/Cu core-shell nanocomposites with WO3

Full factorial design analysis of thermodynamic and kinetic parameters in simulated thermite reaction propagation

Thermal Reactivity of Nanostructure Al0.8mg0.2 Alloy Powder Used in Thermites

Exploring in-situ combustion effects on reservoir properties of heavy oil carbonate reservoir