ДВОМАСОВА МОДЕЛЬ СИСТЕМИ СИЛОВОЇ ГІРОСКОПІЧОЇ СТАБІЛІЗАЦІЇ

Энвер Тапдыг Газарханов,Тогрул Иса Каримли,Васиф Айдын Нейматов

DOI: https://doi.org/10.32620/aktt.2017.6.10

2017-08-12

Aerospace technic and technology

Abstract:The mechanical system of the gyro stabilization device on one axle, consisting of a stabilizing engine and a hinged frame, has been investigated using a two model that adopts as the first mass a stabilizing engine, аnd as an inferred mass, the gyroscope frame of a single axis of the coordinate system. The objective is to draw up a transmission function for the mechanical system of the gyroscope stabilizer in order to obtain transitional processes that meet the conditions of technical period based on known Mathematical models of mechanical conductivity often encountered in the study of mechanical electric power systems. It was proposed to apply the standardized equation of the third order with constant coefficients and to obtain the equations of the moment of inertia, in which the conditions of technical optimum were maintained in any case. It was also suggested that a formula be applied to discriminant a cubic equation in order to obtain calculation formulas to calculate the moments of inertia that provide the conditions of technical optimum. In this case, a definition of the dimensionless parameter, expressed by the multiplicity of the stiffness coefficient value, is given, relative to the value at which the moments of inertia of the mechanical system Gyrostabilizer have zero values, and the defining physical. The meaning of the resulting equations for the mechanical system. In the MATLAB software environment, models have been prepared to derive the transition processes of the two system of Gyrostabilizer, the moments of inertia of the hinged frame and the rotor of the stabilizing engine from the dimensionless parameter, with different values Friction coefficient and transitional processes at different values of the coefficient of multiplicity. The graphs and transition curves that have been obtained demonstrate that the equality of moment of inertia is only possible if the technical optimum is achieved, the oscillation ability transition rate decreases with the increase. A multiplicity coefficient, and the effect of this setting is relatively low during the transition process. Thus, the results obtained from the simulation of computer models confirmed the validity of the studies carried out.