Abstract:Nowadays, consumer trends towards healthier and low fat products have a significant impact on the deep fat frying industry. The objective of this study was to design a modified deep fat fryer (MDF) to have a smaller surface area relative to height, with made a steam blanketing over the fryer. Different levels of water injection flow rates have been used (0.1, 0.2 and 0.3 ml/20 min. per 1 liter of tested oil), compared with conventional fryers (CDF). Frying was conducted at 170 ± 10 °C into sunflower oil using CDF (H√A = 0.24) and MDF (H√A = 0.8) in batch 8 min. 16 batches every day (eight hrs. /day)for up to 40 hrs (Consecutive five days). The modification was intended to related oil deterioration. Water injection had a dual effect. In comparison with CDF, water injection increased the acidity (expressed as oleic acid) from 0.34 % to 0.97 %, after 40 hrs at 170 ± 10 °C of deep fat frying, and a contrarily, the protective role was observed in all the other quality indices. Significant reductions in TBA values (from 8.9 to 4.81mg malonaldehyde/liter of tested oil), P-anisidine values (from 35.6 to 12.9), TPC contents (from 34.5% to 18.64%), conjugated diene (232 nm) (from 8 to 5.59) and conjugated triene (268 nm) (from 1.9 to 1.33) were recorded in sunflower oil compared with CDF. These quality indices of sunflower oil developed dramatically in the first level of water injection flow rate. Consequently, the first level of water injection had the highest (P≥0.05) inhibitory effect compared with the other levels of water injection. Fatty acid composition of fried oil properties during deep frying CDF and MDF designs were determined. There were significant differences (P≥0.05) of fatty acids composition between the fried oil induces during using of CDF and MDF designs. Total unsaturated fatty acid at MDF design gave the highest values. Also, organoleptic evaluation of fried potato chips by CDF and MDF were evaluated by panelists. Fried potato chips during the first level of water injection flow rate had the highest (P≥0.05) flavor (4), crisp (4.5), greasiness (4.6), and overall acceptability (4.8), compared with fried potato chips during other levels of water injection flow rates and with CDF. Findings suggest that determination of the oil quality indices are good makers of sensory evaluation during deep fat frying. Results indicated the changes in moisture content, oil uptake and shrinkage percentages of potato chips at different levels of water injection compared the control samples. The negative correlation coefficient between oil uptake and moisture content was high (r = -0.915) and linear regression equation for prediction the oil uptake y = 34.1064 – 2.0291X. Also, results suggest that during deep fat frying by MDF design may reduce the thermal deterioration of sunflower oil. Water injection can be applied as a simple method to improve oil quality during deep fat frying.

Introducing degummed water‐extracted wild almond oil as a safe vegetable oil through the quality evaluation of par‐fried potato sticks and oil thermo‐oxidative stability during a continuous prolonged deep‐fat frying process

Dynamic changes of fatty acids and related physical & chemical parameters during deep frying in fish oil supplemented blend oil

Quality investigation of the most consumed refined seed oils after French fries’ domestic short-term deep-frying process

Impact of deep-fat frying cycles on the physicochemical characteristics of two edible vegetable oils marketed in Algeria

Analysis of oxidation products and toxic compounds in edible and blended oil during the deep-frying of french fries

Comparison of Non‐volatile Degradation Products Formed from Different Vegetable Oils During Deep Frying of French Fries

Formation of Oxidation Products in Polar Compounds of Different Vegetable Oils During French Fries Deep‐frying

Analysis of 8-oxooctanoate, 9-oxononanoate, fatty acids, oxidative stability, and iodine value during deep-frying of French fries in edible oils blended with palm oil

Comparative Analysis of Frying Performance: Assessing Stability, Nutritional Value, and Safety of High-Oleic Rapeseed Oils

Moringa oleifera Oil Nutritional and Safety Impact on Deep-Fried Potatoes

Effect of Deep Frying of Potatoes and Tofu on Thermo-Oxidative Changes of Cold Pressed Rapeseed Oil, Cold Pressed High Oleic Rapeseed Oil and Palm Olein

Investigation of the Physicochemical Properties of Vegetable Oils Blended with Sesame Oil and Their Oxidative Stability during Frying

Selection of 12 Vegetable Oils Influences the Prevalence of Polycyclic Aromatic Hydrocarbons, Fatty Acids, Tocol Homologs and Total Polar Components During Deep Frying

Improvement in thermal stability of soybean oil by blending with camellia oil during deep fat frying

Evaluation of Chemical and Nutritional Changes in Chips, Chicken Nuggets, and Broccoli after Deep-Frying with Extra Virgin Olive Oil, Canola, and Grapeseed Oils

Influence of steam singlet method on oil quality during deep fat frying on a modified fryer

Effect of kesse, koseret, and tosign extract treatments on the oxidative stability of oil during the repeated frying of potato chips

EFFECT OF DEEP-FAT FRYING ON CANOLA OIL, PALMOLEIN AND SUNFLOWER OIL BLENDS: B) BIOLOGICALAND NUTRITIONAL STUDIES

Comparative assessment of the frying performance of palm olein and sunflower oil during deep-fat frying of Indian battered food products

Evaluation of the non-aldehyde volatile compounds formed during deep-fat frying process

Stability of Bioactive Compounds in Olive-Pomace Oil at Frying Temperature and Incorporation into Fried Foods