Effect of Mechanical Alloying on the Dissolution of the Elemental Mn and Al-Mn Compound in Aluminum

Olga A. Yakovtseva,Nadezhda B. Emelina,Andrey G. Mochugovskiy,Andrey I. Bazlov,Alexey S. Prosviryakov,Anastasia V. Mikhaylovskaya
DOI: https://doi.org/10.3390/met13101765
IF: 2.695
2023-10-18
Metals
Abstract:The grain boundary, solid solution, and precipitation strengthening mechanisms are important for controlling the mechanical properties of Al-based alloys. Due to severe plastic deformation, mechanical alloying refines grain structure to a nanoscale level which leads to a strong increase in solute content and the related strengthening effect of solute atoms and secondary-phase precipitates. This study analyzed the elemental Mn and Al6Mn phase dissolution in Al during high-energy ball milling. For this purpose, XRD data, microstructure, and hardness evolutions were compared for two Al—5.2 at% Mn alloys prepared by mechanical alloying using elemental Al and Mn powders and a pre-melted master alloy. In the two-phase master alloy, containing the Al solid solution and the Al6Mn phase, the strain accumulation, grain refinement, solid solution supersaturation, and milling-induced hardening effects were facilitated. Both elemental Mn and intermetallic compound were dissolved during mechanical alloying, and the maximum solute content was near 3.1 at% Mn. A fine crystalline size of ~25 nm and the maximum Mn solute content were observed after milling of elemental powders and the master alloy for 60 h and 20 h, respectively. The microhardness of ~3 GPa corresponded to a ~3.1% solute Mn content, and the microhardness increased to ~5 GPa after long–term milling due to precipitation strengthening effect of the secondary Al6Mn phase in the master alloy.
materials science, multidisciplinary,metallurgy & metallurgical engineering
What problem does this paper attempt to address?