Abstract:Supercapacitors are gaining increasing attention for complementing or replacing batteries and they are highly desirable in applications where high power and long cycle life of energy storage devices are needed. Activated carbons (AC) are the most promising electrodes in the supercapacitor industry presenting the best performances/cost compromise. Recently, graphene, with a two dimensional carbon nanostructure, has emerged as a new class of promising electrode material in supercapacitors, due to its outstanding properties such as high electric conductivity, high surface area, good mechanical properties and chemical inertia. Among the various approaches to producing graphene materials, here we focus on reduced exfoliated graphene oxide (r-GO) derived from chemically synthesised graphene oxide (GO). However, the graphene materials prepared by either chemical or thermal reduction of the graphene oxide always exhibits a relatively low electrochemical performance due to the agglomeration of graphene sheets and does not reflect the intrinsic capacitance of an individual graphene nano-sheet. To exploit the potential electrochemical applications for graphene, a particularly attractive option is to design and develop composites of graphene with other materials. In this study, we present an approach to synthesize a composite of reduced graphene oxide (r-GO) with activated carbon and its use as an electrode material in supercapacitors. To the best of our knowledge, a few studies on the preparation of GO/AC composites have been reported so far. Graphene oxide was synthesised using vein graphite by a modified Hummers method and then mixed with activated carbon to prepare a homogeneous composite. The composite was thermally reduced to convert GO in to r-GO. The morphology and chemical structure of the materials were characterized by means of Electron microscopy, Raman spectroscopy, X-ray diffraction and Fourier Transform Infrared Spectroscopy. Thermal properties were investigated using Thermo Gravimetric Analysis. The electrochemical properties of as obtained composites with different mass ratios were investigated, together with their individual components (GO, r-GO and AC) for comparison. For electrochemical characterisation, two-electrode symmetrical supercapacitor cells were constructed and characterized by cyclic voltammetry and electrochemical impedance spectroscopy. Tetraethylammonium tetrafluoroborate (TEABF4) in Propylene Carbonate (PC) was used as the electrolyte. The CV curves were measured from 0 to 1 V with various scan rates ranging from 10 to 1000 mV s −1 and the CV data were used to calculate the specific capacitances of the electrodes. The results showed that the as-prepared composites exhibited an improved electrochemical performance as compared to pure r-GO or AC. This improvement can be attributed to the synergistic effect of AC and r-GO. The maximum specific capacitance observed for the r-GO/ AC composite was 115.6 F/g at a scan rate of 10 mV s -1 . The near-rectangular CV curves at ultrafast sweep rate of 1000 mV s -1 indicated very efficient charge transfer within the composite electrodes. The incorporation of rGO into AC, not only provides the vacancies to accommodate ions, but also forms a promising network structure to conductively bridge the spaces between the AC particles, which can facilitate rapid transport of the electrolyte ions within the electrode materials, leading to a high-rate performance of the supercapacitor. Within the composite, r-GO plays the role of both the binder and the conductive additive increasing the specific capacitance and the power density of the devices.

Optimized Graphene Hydrogels for Electrochemical Applications from High-Concentration GO/Gnp Dispersions

Graphene Aerogel Derived by Purification-Free Graphite Oxide for High Performance Supercapacitor Electrodes

Optimized hydrogel electrodes for supercapacitors from high-concentration aqueous graphene nanoplatelet dispersions

Direct 3 D Printing of Ultralight Graphene Oxide Aerogel

Purified Nitrogen-Doped Reduced Graphene Oxide Hydrogels for High-Performance Supercapacitors

Optimized Supercapacitive Performance of Graphene-Hydrogel by Porous Texture Controlling

GO Regulated Hydrogel Electrolytes with Superior Conducing and Antiswelling Ability for Flexible Supercapacitors

Graphene Oxide and Activated Carbon Composites for High-Power Supercapacitors

Dimethylsulfoxide-Dependent Environments for Fabricating Graphene Hydrogels for High-Performance Supercapacitor.

Hydrothermal Synthesis of Macroscopic Nitrogen-Doped Graphene Hydrogels for Ultrafast Supercapacitor

Resilient 3D Porous Self-Healable Triple Network Hydrogels Reinforced with Graphene Oxide for High-Performance Flexible Supercapacitors

Understanding Self-assembly, Colloidal Behavior and Rheological Properties of Graphene Derivatives for High-performance Supercapacitor Fabrication

Nanocellulose/nitrogen and fluorine co-doped graphene composite hydrogels for high-performance supercapacitors

Reduced Graphene Oxide Hydrogel for High Energy Density Symmetric Supercapacitor with High Operation Potential in Aqueous Electrolyte

Electroactive biopolymer/graphene hydrogels prepared for high-performance supercapacitor electrodes

A High‐Performance Graphene Oxide‐Doped Ion Gel As Gel Polymer Electrolyte for All‐Solid‐State Supercapacitor Applications

Potassium citrate mediated self-restacking of graphene oxide to highly-microporous carbon nanosheets for high-performances supercapacitor

Application of N/P-rGO composite electrode materials and novel electrolytes in high-performance supercapacitors

High-Performance Self-Assembled Graphene Hydrogels Prepared by Chemical Reduction of Graphene Oxide

Polyacrylamide/EDTA-modified chitosan/graphene oxide hydrogels as an adsorbent and supercapacitor for sustainable applications

Self-assembled Three-Dimensional Hierarchical Graphene/polypyrrole Nanotube Hybrid Aerogel and Its Application for Supercapacitors.