Abstract:All-carbon flexible supercapacitors are highly promising in powering up wearable electronics in smart textiles. However, their low energy density hinders their practical application due to the lack of an effective fabrication method of highly conductive fiber electrodes with high specific capacitance. Herein, we develop a sustainable, scalable, and cost-effective method to fabricate lignin-based carbon/graphene fiber (GF) hybrid electrodes with a hierarchically porous structure. This engineered structure is achieved by coaxially wet spinning a graphene oxide fiber (GOF) as a core structural support and 0–10% lignin/graphene oxide (GO) as a surface layer, followed by carbonization and KOH activation processes. The obtained fiber electrodes exhibit the highest specific capacitance of 260.48 mF cm–2 at a current density of 0.1 mA cm–2, which is 11 times that of the neat GF from conventional wet spinning. The entire-device energy density of the assembled fiber-based flexible supercapacitors from the optimal fiber electrode is 5.79 μW h cm–2 in a H2SO4/poly(vinyl alcohol) electrolyte. Furthermore, the fiber-based flexible supercapacitors show ultralong cycling life and cycling stability (the capacitance retention rate is 98% after 7000 cycles of charge/discharge at a current density of 0.1 mA cm–2). This work enables the high-value utilization of low-cost carbon precursors (lignin and GO) in potential applications such as energy storage devices for smart textiles.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsaem.1c01379.Polarized optical microscopy image of GO solution at 15 mg mL–1; SEM images of the neat GF and unactivated 5% ; FTIR images of the GOF and GF; CV and GCD curves of the GF, unactivated 5% recorded at 5 mV s–1 and 0.1 mA cm–2; CV and GCD curves of flexible supercapacitors tested in a 2-electrode cell in 1 M H2SO4/PVA electrolyte of 0–10% ; electrical conductivity of ; calculated CA, CV, Esingle,A, and Psingle,A values of fiber electrodes based on GCD curves at a current density of 0.1 mA cm–2; calculated CA of fiber electrodes at different scan rates based on CV measurements; and calculated CA of fiber electrodes at current densities based on GCD measurements (PDF)This article has not yet been cited by other publications.

Electroactive biopolymer/graphene hydrogels prepared for high-performance supercapacitor electrodes

Design of Fe3+-Rich, High-Conductivity Lignin Hydrogels for Supercapacitor and Sensor Applications.

All-solid-state Supercapacitors from Natural Lignin-Based Composite Film by Laser Direct Writing

GO Regulated Hydrogel Electrolytes with Superior Conducing and Antiswelling Ability for Flexible Supercapacitors

Chitosan/graphene oxide hybrid hydrogel electrode with porous network boosting ultrahigh energy density flexible supercapacitor

Controlled Swelling of Graphene Films Towards Hierarchical Structures for Supercapacitor Electrodes

Electrochemical Performance of Coaxially Wet-Spun Hierarchically Porous Lignin-Based Carbon/Graphene Fiber Electrodes for Flexible Supercapacitors

Preparation of lignosulfonate ionic hydrogels for supercapacitors, sensors and dye adsorbent applications

Wet-spun, porous, orientational graphene hydrogel films for high-performance supercapacitor electrodes.

Pulsed electrochemical fabrication of graphene/polypyrrole composite gel films for high performance and flexible supercapacitors

A Triblock Copolymer Design Leads to Robust Hybrid Hydrogels for High-Performance Flexible Supercapacitors

Chitosan-based oxygen-doped activated carbon/graphene composite for flexible supercapacitors

Tuning the Electronic and Electrochemical Properties of 3D Porous Laser‐Induced Graphene by Electrochemically Induced Deposition of Polyoxovanadate Nanoclusters for Flexible Supercapacitors

Depositing Reduced Graphene Oxide on Electroless Plating Ni/organic Polymer Fibrous Membrane for Flexible Supercapacitors

Lignin-containing hydrogel matrices with enhanced adhesion and toughness for all-hydrogel supercapacitors

Preparation of Graphene Oxide/La2Ti2O7 Composites with Enhanced Electrochemical Performances for Supercapacitors

Direct Patterning of Conductive Structures on Hydrogels by Laser‐Based Graphitization for Supercapacitor Fabrication

Quinoline-2,3-dicarboxylic Acid-Modified Graphene Hydrogel Composites for High-Performance Asymmetrical Supercapacitors

Preparation of morphology-controllable polyaniline and polyaniline/ graphene hydrogels for high performance binder-free supercapacitor electrodes

Rational design of active layer configuration with parallel graphene/polyaniline composite films for high-performance supercapacitor electrode

Optimized Graphene Hydrogels for Electrochemical Applications from High-Concentration GO/Gnp Dispersions