Yang Li,Jian-Liang Zhang,Zheng-Jian Liu,Long-Zhi Chen,Yao-Zu Wang,Jian-liang Zhang,Zheng-jian Liu,Long-zhi Chen,Yao-zu Wang
Abstract:<p>Municipal solid waste incinerator fly ash (MSWI FA) is a type of waste that is harmful to the environment, and the melting treatment methods can treat MSWI FA, removing its potential negative impacts. However, special equipment is required for the FA melting process, which necessitates high costs. Metallurgical shaft furnaces (MSF) can melt MSWI FA efficiently. Therefore, the feasibility of using an MSF for FA treatment was studied herein. First, the fundamental physicochemical properties of the FA were analyzed. Then, the appearance and internal morphology of the FA were examined using a scanning electron microscope. Finally, melting experiments were designed according to the conditions of the MSF. The results show that slag changes into a glassy state under rapid cooling, which is beneficial to the solidification of harmful elements. These harmful elements, including Pb, Zn, and Cu, are thus reduced and volatilized into the flue gas under the MSF's reducing atmosphere. The harmful elements that enter the slag are solidified, causing its leaching toxicity to achieve the national standard requirements. Further, under the simulated MSF smelting conditions, the FA dioxin destroy removal efficiency realized more than 99.99% efficiency. Therefore, the harmless treatment of MAWI FA can be realized through MSF process.</p>
What problem does this paper attempt to address?
The paper mainly discusses the feasibility of using a Metallurgical Shaft Furnace (MSF) for the harmless treatment of Municipal Solid Waste Incinerator Fly Ash (MSWI FA). MSWI FA is a type of waste harmful to the environment, containing dioxins and hazardous elements such as mercury, zinc, arsenic, lead, cadmium, chromium, and copper. Traditional melting treatment methods can remove these potential negative impacts but require special equipment and are costly.
The paper points out that MSF can efficiently melt MSWI FA. The research first analyzed the basic physical and chemical properties of the fly ash, then examined its appearance and internal morphology using a scanning electron microscope. Melting experiments were designed according to the conditions of the MSF. The results show that under rapid cooling, the slag turns into a glass state, which is beneficial for the solidification of hazardous elements. Under a reducing atmosphere, hazardous elements including lead, zinc, and copper are reduced and volatilized into the flue gas. The hazardous elements that enter the slag are solidified, making their leaching toxicity meet national standards. Under simulated MSF smelting conditions, the destruction and removal efficiency of dioxins in fly ash exceeds 99.99%, thus, the MSF process can achieve the harmless treatment of MSWI FA.
Furthermore, the paper discusses the chemical composition of MSWI FA, the content of hazardous elements and dioxins, mineral phases, and microstructure, and describes in detail the experimental methods, including melting experiments, analysis of hazardous elements, characterization of mineral phases and microstructure, thermodynamic calculations, and leaching toxicity tests. Finally, the paper studies the effects of cooling modes, melting temperature, and time on the solidification of hazardous elements and the degradation of dioxins through experimental research, concluding that the MSF process is effective for the harmless treatment of MSWI FA and can significantly reduce construction costs. Future research will focus on the entire process of MSWI FA melting treatment, including the agglomeration process of fly ash, treatment of water-quenched slag wastewater, harmless treatment of secondary fly ash, and the comprehensive utilization of water-quenched slag.