Abstract:The multicore fiber amplifier, as a key component in spatial division multiplexing (SDM) communication systems, presents higher technical difficulty compared to traditional multi-channel single core fiber amplifiers, which has sparked widespread attention. To achieve balance, efficiency, miniaturization, and cost-effectiveness in the performance of multi-core optical fiber amplifiers, we propose an innovative triple cladding 13-core Er/Yb co-doped microstructured fiber (13CEYDMOF). The proposed fiber features an outer cladding with peanut-shaped air holes, which enables uniform excitation of the 13 cores using a single multimode laser pump source within the inner cladding. This approach also prevents damage or aging of the fiber's outer coating due to the pump laser. Furthermore, the design of Peanut-Shaped Air Holes effectively increases the numerical aperture (NA) of the inner cladding while reducing the outer diameter of the fiber, enhancing the fiber's mechanical flexibility. To address the coupling difficulties caused by air holes, we bi-directionally pump the 13CEYDMOFA by utilizing a combined technique of the side winding and end pumping. The experimental results show that the 13CEYDMOFA can achieve an average gain of 23.8 dB, a noise figure (NF) of ∼4.6 dB, and an inter-core gain difference of less than 2 dB in the wavelength range of 1529–1565 nm. The in-line amplified transmission experiment demonstrates that the 13CEYDMOFA is well suited for the 13 spatial channels transmission. To the best of our knowledge, this is the first time to realize high performance telecommunication band amplification in a multicore microstructure fiber.

M-type refractive index profile erbium-doped fiber for high-efficiency multicore EDFA

Simultaneously Achieving a Large Negative Dispersion and a High Birefringence Over Er and Tm Dual Gain Bands in a Square Lattice Photonic Crystal Fiber

High Power-Efficiency, Low DMG Cladding-Pumped Few-Mode Er/Yb/P Co-Doped Fiber Amplifier for Mode Division Multiplexing

A novel multicore Er/Yb co-doped microstructured optical fiber amplifier with peanut-shaped air holes cladding

Design of 125-Μm Cladding Diameter Multicore Fibers with High Core Multiplexing Factor for Wideband Optical Transmission

145 W single-frequency fiber laser at 1607 nm with the seed and MOPA configuration

Analysis of Erbium-Doped Segmented-Cladding Fiber for Optical Amplification

Design of Solid-Core Bragg Few-Mode Fiber for Short-Reach MDM Networks in O+C+L Band

Improvement of differential modal gain in a ring-core few-mode erbium-doped polymer optical waveguide amplifier

Analysis of Erbium-Doped Ultralarge-Core Segmented-Cladding Fibers for Optical Amplification

Analysis of Ytterbium-Doped Gain Guided and Index Antiguided Fiber Amplifier

High-efficiency cladding-pumped Er/Yb co-doped alumino-phosphosilicate fiber for an extended L-band amplification

A 7-core erbium doped double-clad fiber amplifier with side-coupled pumping

Orbital Angular Momentum Mode-Multiplexed Amplification and Transmission Based on a Ring-Core Erbium-Doped Fiber

Weakly-Coupled MDM-WDM Amplification and Transmission Based on Compact FM-EDFA

Large-Mode-Area Neodymium-Doped All-Solid Double-Cladding Silicate Photonic Bandgap Fiber With A 32 Mu M Core Diameter

Low-modal-crosstalk Doped-Fiber Amplifiers in Few-Mode Fiber-Based Systems

Multiple-Ring-Core FM-EDF for Weakly-Coupled MDM Amplification with Low Differential Modal Gain

Gain Performances of 980 Nm-Pumped Erbium-Doped Fiber Amplifiers

Design of a Few-Mode Erbium-Ytterbium Co-Doped Polymer Optical Waveguide Amplifier With Low Differential Modal Gain

High-Speed Performance Evaluation of Graded-Index Multicore Fiber Compatible With Multimode and Quasi-single Mode Operation