Additive Manufacturing of Flexible Strain Sensors based on Smart Composites for Structural Health Monitoring with High Accuracy and Fidelity

Sheraz Ahmed,Mahdi Bodaghi,Saad Nauman,Zaffar Muhammad Khan

DOI: https://doi.org/10.1002/adem.202300763

IF: 3.6

2023-09-07

Advanced Engineering Materials

Abstract:This research introduces novel flexible spherical carbon nanoparticle‐based polyurethane conductive ink, which is employed to 3D print strain sensors by a lab‐developed Direct Ink Writing system. Rheological tests are performed, and sensors are pasted on Glass‐Fiber‐Reinforced Plastic specimens to study strain gauge behaviors under quasi‐static loading. The gauge factor in tensile loading is found to be layer width dependent as decreasing the strain gauge's layer width increases the sensitivity of the strain sensor. A maximum gauge factor of 34 is achieved using a layer width of 0.2mm, 17 times greater than commercially available metal foil strain gauges. The four‐point bend tests are performed under tension/compression to assess the sensor's strain‐sensing and damage‐monitoring ability. Fractographic analysis is coupled with strain monitoring using the developed sensor, which confirms that the failure progresses from intralaminar failure modes such as ply splitting in tension. At the same time, delamination leads to kink band formation under compression and the eventual failure of load‐bearing fibers. The developed sensor exhibits repeatable performance with low hysteresis and integrated non‐linearity errors for up to 1000 cycles. The developed sensors could be effectively employed for online in‐situ structural health monitoring of structures in different applications under static and dynamic loading. This article is protected by copyright. All rights reserved.

materials science, multidisciplinary