Abstract:Achieving a viable process for three-dimensional (3D) printing of ceramics is a sought-after goal in a wide range of fields including electronics and sensors for harsh environments, microelectromechanical devices, energy storage materials, and structural materials, among others. Low laser absorption of ceramic powders renders available additive manufacturing (AM) technologies for metals not suitable for ceramics. Polymer solutions that can be converted to ceramics (preceramic polymers) offer a unique opportunity to 3D-print ceramics; however, due to the low viscosity of these polymers, so far, their 3D printing has only been possible by combining them with specialized light-sensitive agents and subsequently cross-linking them layer by layer by rastering an optical beam. The slow rate, lack of scalability to large specimens, and specialized chemistry requirements of this optical process are fundamental limitations. Here, we demonstrate 3D printing of ceramics enabled by dispensing the preceramic polymer at the tip of a moving nozzle into a gel that can reversibly switch between fluid and solid states, and subsequently thermally cross-linking the entire printed part "at-once" while still inside the same gel. The solid gel, which is composed of mineral oil and silica nanoparticles, converts to fluid at the tip of the moving nozzle, allows the polymer solution to be dispensed, and quickly returns to a solid state to maintain the geometry of the printed polymer both during printing and the subsequent high-temperature (160 °C) cross-linking. We retrieve the cross-linked part from the gel and convert it to ceramic by high-temperature pyrolysis. This scalable process opens up new opportunities for low-cost and high-speed production of complex three-dimensional ceramic parts and will be widely used for high temperature and corrosive environment applications, including electronics and sensors, microelectromechanical systems, energy and structural applications.

Infrared Irradiation to Drive Phosphate Condensation as a Route to Direct Additive Manufacturing of Oxide Ceramics

Hydrothermal treatment of alumina powders to alter the low-temperature binding of chemically bonded phosphate ceramic composites via infrared irradiation

Additive manufacturing of ceramics from preceramic polymers: A versatile stereolithographic approach assisted by thiol-ene click chemistry

Tomographic Volumetric Additive Manufacturing of Silicon Oxycarbide Ceramics

Synergistic regulation of sintering temperature in calcium silicide-infused porcelain ceramic 3D printing for dephosphorization and deoxygenation

On enhancing the manufacturability and conversion of additively manufactured polymer-derived ceramics

Photopolymerization-based additive manufacturing of ceramics: A systematic review

Potential and challenges for Powder Bed Fusion – Laser Beam (PBF-LB) in industrial ceramic additive manufacturing

Reactive Two-Step Additive Manufacturing of Ultra-high Temperature Carbide Ceramics

Design and Manufacturing of Si-Based Non-Oxide Cellular Ceramic Structures through Indirect 3D Printing

Three-Dimensional Printing of Ceramics through "Carving" a Gel and "Filling in" the Precursor Polymer

Customized Nanostructured Ceramics via Microphase Separation 3D Printing

Direct Ink Writing of Bismuth Molybdate Microwave Dielectric Ceramics

Direct laser melting of Al2O3 ceramic paste for application in ceramic additive manufacturing

Additive manufacturing of flexible polymer-derived ceramic matrix composites

Alumina–zirconium ceramics synthesis by selective laser sintering/melting

From rapid prototyping to rapid firing: on the feasibility of high‐speed production for complex BaTiO3 components

Direct ink writing of aluminum-phosphate-bonded Al2O3 ceramic with ultra-low dimensional shrinkage

Coupling additive manufacturing and microwave sintering: A fast processing route of alumina ceramics

A novel composite binder design for direct ink writing alumina-based ceramics with enhanced strength at low sintering temperature

Advances and Challenges in Direct Additive Manufacturing of Dense Ceramic Oxides