Radiation‐Induced Admicellar Graft Polymerization of 2‐Hydroxyethyl Methacrylate onto Polyvinylidene Fluoride Membranes Using an Electron Beam Accelerator

Muhammad Irfan Mustaqim Azzian,Siti Fatahiyah Mohamad,Nik Muhamad Faris Hakimi Abd Rahim,Mohamad Amirul Aizat Abdul Manaf,Devi Durgaashini A/P Ramesh,Thirunaukkarasu A/L Asogan,Nor Hafiza Ismail,Wan Norharyati Wan Salleh
DOI: https://doi.org/10.1002/ceat.202300014
2023-08-24
Abstract:The graft polymerization of 2‐hydroxyethyl methacrylate onto a polyvinylidene fluoride (PVDF) membrane by admicellar polymerization was accomplished using graft polymerization induced by radiation. Electron beam irradiation was applied to covalently activate more free radicals to graft the copolymer. The effect on the physicochemical properties of PVDF before and after modification was investigated. The efficiency of admicellar graft polymerization in functionalizing polyvinylidene fluoride (PVDF) membranes was explored. The effect of 2‐hydroxyethyl methacrylate (HEMA) concentration and the absorbed dose was investigated using a simultaneous method of radiation‐induced graft polymerization. The degree of grafting increased with raising the absorbed dose and HEMA concentration. The Fourier transform infrared (FTIR) peak for C–O stretch and the asymmetric and symmetric stretching of the C–O–C bridge, respectively, proved the presence of poly(2‐hydroxyethyl methacrylate) (PHEMA) on the modified PVDF. As the grafting yield increased, rougher surfaces were observed. According to contact angle analysis, the grafted membrane with a higher grafting yield outperformed the low grafting yield membrane in terms of water flux and hydrophilicity.
engineering, chemical
What problem does this paper attempt to address?