Abstract:Thin-walled structures are now widely used in aerospace structural components, turbines and many other applications, while the control of machining distortion has become one of the most difficult problems influencing their machining quality. Machining distortion is the result of many factors, among which the machining induced residual stress is an important issue. In this paper, a finite element analysis (FEA) approach of predicting machining induced residual stresses and the consequent distortion is presented, which includes the simulation of machining process, processing of the extracted residual stress data, loading of the fitted stress data and distortion analysis. Professional metal cutting simulation and optimization software, TWS AdvantEdge, was used for 3D machining process simulation. The constitutive model of work piece material was obtained from pressure bar tests and orthogonal cutting tests, and has been proved of good accuracy. General FEM software ABAQUS was used to create and mesh the thin-plate work piece. The meshing data outputted from ABAQUS and stress data calculated by AdvantEdge were processed with MATLAB, obtaining the stress distribution of each element, and then the stress distribution was input back into ABAQUS to calculate the distortion. Experiments were carried out, measuring the residual stress and distortion, to verify the FEM simulation. Under the designed simulation and experiment conditions, the machining induced residual stresses in feeding and peripheral directions are both tensile at the machined surface and fall off to a maximum compressive state with the increase in depth, after which the compressive stresses decrease and approach a steady value next to zero in near work piece substrate. Both experimental and FEA simulation results show that the release of the residual stresses make the thin plate to become convex. Yet there are still differences in conditions between simulation and experiment, and further will be carried out- to improve the accuracy.

The Residual Stress Control of Thin-walled Sleeve Parts with Weak Rigidity

Finite Element Simulation and Analysis of Deformation in Machining of Aeronautical Aluminum Alloy Thin-Walled Workpiece

The Residual Stress and Deformation Control of TC4 Thin-Walled Outer Ring Components by Ultrasonic Regulation

Finite Element Method Simulation for Residual Stress in Quenched Aluminum Alloy Thick-Plate and Its Effect on Machining Distortion

Ultrasonic stress detection and regulation in the whole machining process of thin-walled part

Study on Residual Stress and Ultrasonic Deformation Control of Titanium Alloy Cylinder Components

A novel method to control stress distribution and machining-induced deformation for thin-walled metallic parts

The Residual Stress Relief and Deformation Control of Al Alloy Thin-Walled Antenna Components by Ultrasonic Regulation

Analysis and Simulation of Machining Deformation Resulting from Residual Stress

Residual stress relaxation considering microstructure evolution in heat treatment of metallic thin-walled part

Effects of TVSR process on the dimensional stability and residual stress of 7075 aluminum alloy parts

Study on the surface grain state, residual stress and their influence on the deformation of thin-walled parts under ultra-precision cutting

Investigation on influences of initial residual stress on thin-walled part machining deformation based on a semi-analytical model

An Experimental Investigation into Residual Stress Control of 24CrNiMo Alloy Steel by Selective Laser Melting

Residual compressive stress prediction determined by cutting-edge radius and feed rate during milling of thin-walled parts

Regulation of residual stress in elastic solid component with high-energy acoustic field

Numerical Simulation Investigation on Machining Deformation of Aviation Thin-Walled Parts Caused by Residual Stress

Residual stress prediction in ultrasonic vibration–assisted milling

Finite element analysis of residual stresses and thin plate distortion after face milling

A machining deformation control method of thin-walled part based on enhancing the equivalent bending stiffness

Recent Progress in Residual Stress Measurement Techniques