Abstract:Thin-walled structures are now widely used in aerospace structural components, turbines and many other applications, while the control of machining distortion has become one of the most difficult problems influencing their machining quality. Machining distortion is the result of many factors, among which the machining induced residual stress is an important issue. In this paper, a finite element analysis (FEA) approach of predicting machining induced residual stresses and the consequent distortion is presented, which includes the simulation of machining process, processing of the extracted residual stress data, loading of the fitted stress data and distortion analysis. Professional metal cutting simulation and optimization software, TWS AdvantEdge, was used for 3D machining process simulation. The constitutive model of work piece material was obtained from pressure bar tests and orthogonal cutting tests, and has been proved of good accuracy. General FEM software ABAQUS was used to create and mesh the thin-plate work piece. The meshing data outputted from ABAQUS and stress data calculated by AdvantEdge were processed with MATLAB, obtaining the stress distribution of each element, and then the stress distribution was input back into ABAQUS to calculate the distortion. Experiments were carried out, measuring the residual stress and distortion, to verify the FEM simulation. Under the designed simulation and experiment conditions, the machining induced residual stresses in feeding and peripheral directions are both tensile at the machined surface and fall off to a maximum compressive state with the increase in depth, after which the compressive stresses decrease and approach a steady value next to zero in near work piece substrate. Both experimental and FEA simulation results show that the release of the residual stresses make the thin plate to become convex. Yet there are still differences in conditions between simulation and experiment, and further will be carried out- to improve the accuracy.

Numerical Simulation Investigation on Machining Deformation of Aviation Thin-Walled Parts Caused by Residual Stress

Finite Element Simulation and Analysis of Deformation in Machining of Aeronautical Aluminum Alloy Thin-Walled Workpiece

Finite Element Method Simulation for Residual Stress in Quenched Aluminum Alloy Thick-Plate and Its Effect on Machining Distortion

Study on Machining Deformation of Aircraft Monolithic Component by FEM and Experiment

Numerical Simulation and Analysis of Symmetry and Step-symmetry Milling of Aerospace Thin-walled Workpiece

Study on Milling Deformation of Aerospace Frame Monolithic Components

Machining Distortion Prediction of Aerospace Monolithic Components

Constitutive Model of Aviation Aluminum-Alloy Material in Metal Machining

Study on the Machining Distortion of Thin-walled Part Caused by Redistribution of Residual Stress

Milling Error Prediction of Thin-Walled Parts During High-Speed Machining

Analysis and Simulation of Machining Deformation Resulting from Residual Stress

Investigation on influences of initial residual stress on thin-walled part machining deformation based on a semi-analytical model

Finite element analysis of residual stresses and thin plate distortion after face milling

Study on Modeling of Numerical Simulation Milling Deformation for Aerospace Frame Monolithic Components

Machining-induced residual stress and deformation during Mg–Li alloy thin-walled rib-web parts milling

Prediction Model for the Evolution of Residual Stresses and Machining Deformation of Uneven Milling Plate Blanks

Semi-Analytical Solution Model for Bending Deformation of T-Shaped Aviation Aluminium Alloy Components under Residual Stress

Modeling of Machining Distortion for Thin-Walled Components Based on the Internal Stress Field Evolution

Research on machining deformation of aluminum alloy rolled ring induced by residual stress

Study on Residual Stress Produced in Milling of Aeronautic Structure

Finite Element Simulation and Deformation Control of High-Speed Milling of Al7050-T7451 Thin-walled Parts