Abstract:As the monitoring of carbon dioxide is an important proxy to estimate the air quality of indoor and outdoor environments, it is essential to obtain trustful data from CO2 sensors. However, the use of widely available low-cost sensors may imply lower data quality, especially regarding accuracy. This paper proposes a new approach for enhancing the accuracy of low-cost CO2 sensors using an extremely randomized trees algorithm. It also reports the results obtained from experimental data collected from sensors that were exposed to both indoor and outdoor environments. The indoor experimental set was composed of two metal oxide semiconductors (MOS) and two non-dispersive infrared (NDIR) sensors next to a reference sensor for carbon dioxide and independent sensors for air temperature and relative humidity. The outdoor experimental exposure analysis was performed using a third-party dataset which fit into our goals: the work consisted of fourteen stations using low-cost NDIR sensors geographically spread around reference stations. One calibration model was trained for each sensor unit separately, and, in the indoor experiment, it managed to reduce the mean absolute error (MAE) of NDIR sensors by up to 90%, reach very good linearity with MOS sensors in the indoor experiment (r2 value of 0.994), and reduce the MAE by up to 98% in the outdoor dataset. We have found in the outdoor dataset analysis that the exposure time of the sensor itself may be considered by the algorithm to achieve better accuracy. We also observed that even a relatively small amount of data may provide enough information to perform a useful calibration if they contain enough data variety. We conclude that the proper use of machine learning algorithms on sensor readings can be very effective to obtain higher data quality from low-cost gas sensors either indoors or outdoors, regardless of the sensor technology.

On Data-Driven Self-Calibration for IoT-Based Gas Concentration Monitoring Systems

Calibrating Low-Cost Sensors by a Two-Phase Learning Approach for Urban Air Quality Measurement

Dynamic Measurement and Data Calibration for Aerial Mobile IoT

Deep Gaussian Mixture Adaptive Network for Robust Soft Sensor Modeling with a Closed-Loop Calibration Mechanism

Multihop Calibration for Mobile Sensing: K-hop Calibratability and Reference Sensor Deployment

Observability-Aware Intrinsic and Extrinsic Calibration of LiDAR-IMU Systems

An Online Calibration Method Based on n-Tuple and Opportunistic Communication for Mine Mass Portable Gas Sensors

Lightweight Self-Detection and Self-Calibration Strategy for MEMS Gas Sensor Arrays

In Situ Blind Calibration of Sensor Networks for Infrastructure Monitoring

Gas Concentration Retrieval Algorithm Based on Kalman Filtering Theory

Individualized Calibration of Industrial-Grade Gas Sensors in Air Quality Sensing System

Strategy to Expedite Gas Sensor Calibration Based on Cyclic Temperature Operation and Data Augmentation

A Novel Calibration Scheme of Gas Sensor Array for a More Accurate Measurement Model of Mixed Gases

Deep Learning Based Calibration Time Reduction for MOS Gas Sensors with Transfer Learning

A Global Multi-Unit Calibration as a Method for Large Scale IoT Particulate Matter Monitoring Systems Deployments

Calibration Assessment of Low-Cost Carbon Dioxide Sensors Using the Extremely Randomized Trees Algorithm

Low-Cost CO Sensor Calibration Using One Dimensional Convolutional Neural Network

On-line sensor calibration transfer among electronic nose instruments for monitoring volatile organic chemicals in indoor air quality

Design a wireless sensor network for methane monitoring system

Co-training Neural Network-Based Infrared Sensor Array for Natural Gas Monitoring

Overcoming traceability challenge in air quality measurements by developing reference gas mixtures of CO2 in a typical indoor/outdoor range for future relevant IoT technology applications