Abstract:Ammonia is being considered as a promising zero carbon fuel due to its unique properties, while its combustion still poses challenges in term of instability and higher nitrogen oxides (NO x ) emissions. In this study, the co-combustion stability of ammonia/methane with air under lean burn condition is experimentally investigated using a silicon carbide (SiC) ceramic foam burner with a two-layer structure stabilizing the flame. The influences of different operating parameters (methane fraction ω , equivalence ratio φ , and flow velocity V ) on the co-combustion flame temperature and emissions are analyzed. The results indicate that the lean stable co-combustion of ammonia/methane with air can be achieved in two-layer ceramic foam burner, with its lower limit extending to φ = 0.5, even for the pure ammonia at specific operating conditions. Notably, the nitric oxide (NO) emissions decrease significantly as the equivalence ratio increases, particularly with a rise in methane fraction. The reduction can reach as low as 843 ppm with φ increasing to 0.9, further reducing to an ultra-low level of less than 150 ppm at φ = 1.3, significantly lower than those of traditional free flame burners. Carbon monoxide (CO) emissions remain at ultra-low levels, indicating the excellent co-combustion efficiency of ammonia/methane-air in the porous burner. An optimal co-combustion region with lower NO and CO emissions were conclusively identified. These findings demonstrate the effectiveness of porous media combustion in improving the co-combustion stability of ammonia/methane and reducing NO emissions, thereby helping to develop the porous burners of ammonia-based fuel and promoting its clean utilization for realizing carbon neutrality.

Lean premixed combustion of methane-air in a novel preheated miniature combustor with a flame holder and porous medium

Combustion and thermal performance of a novel preheated miniature combustor with a flame holder and various porous medium materials

Experimental investigation on flame stability and emissions of lean premixed methane–air combustion in a developed divergent porous burner

Experimental Investigation of Lean Methane–Air Laminar Premixed Flames at Engine-Relevant Temperatures

Experimental investigation on dynamic characteristics of methane/air combustion in double‐layer pellets porous media

Performance Evaluation of Low-Concentration Methane Combustion in a Four-Layer Gradually-Varied Porous Burner

Stability of Lean Combustion in Mini-Scale Porous Media Combustor with Heat Recuperation

Experimental and Numerical Study on the Combustion Characteristics of Premixed Methane/Air in Porous Media Burner

Experimental Study on the Combustion Characteristics of Ultralow-Concentration Methane in Divergent Porous Media Burner

Flame Front Stability of Low Calorific Fuel Gas Combustion with Preheated Air in a Porous Burner

Experimental study on the premixed lean-burn in alumina particles based porous burner

Flame Propagation of Premixed Gas with Enhanced Heat Recirculation: Dynamic Characteristics of Lean and Rich Combustion

Numerical and Experimental Investigations on Combustion Characteristics of Premixed Lean Methane–Air in a Staggered Arrangement Burner with Discrete Cylinders

Lean Methane Premixed Combustion over a Catalytically Stabilized Zirconia Foam Burner

Experimental and Computational Study of the Combustion Characteristics of Dual-Stage Lean Premixed Flame

Experiment on Lean Fuel Combustion in Porous Media Combustor with External Swiss-roll

Experimental investigation on non-premixed methane/air combustion in Y-shaped meso-scale combustors with/without fibrous porous media

Experimental And Numerical Investigations Of Low-Swirl Multi-Nozzle Combustion In A Lean Premixed Combustor

Investigation on Bluff-Body and Swirl Stabilized Flames Near Lean Blowoff with PIV/PLIF Measurements and LES Modelling

Stable lean co-combustion of ammonia/methane with air in a porous burner

Lean Biogas-Air Mixture Combustion on Porous Burner with a Flamethrower Ignition System