Abstract:Structural Health Monitoring, Ahead of Print. Thermal integrity testing has been successfully used to assess the quality of cast-in-place piles for the past decade. It employs temperature data measured during concrete curing to identify defects along the piles' length. However, the uptake of this technology has been rather limited in the piling industry. The main concerns are that the method is not standardised and its reliability is not well understood. In order to address these, there are a number of fundamental questions that need to be explored in more detail, including (a) the optimum time to conduct the assessment, (b) the defect thermal impact, (c) the zone of influence on temperature sensors, (d) the minimum detectable size of a defect and (e) the associated optimum sensor location required. In this paper, experimental and numerical studies were conducted to examine these questions. Fibre optic sensors were employed on model concrete piles in laboratory tests to provide fully distributed temperature data throughout the curing process. The test results showed that the optimum time to assess the defects is approximately at 60% of the time to reach peak temperature and the minimal detectable defect size, using the currently available optical fibre sensor technology, is 4% of the cross-sectional area. In addition, the thermal influence of different defect sizes is presented. Following this, it is shown in the paper that the minimum numbers of sensor cables required to identify defects with cross-sectional areas of 4%, 5% and 8% are eight, six and four cables, respectively. The optimum layout of these sensor cables within a pile cross-section has also been discussed. When specifying pile instrumentation for integrity assessment, the findings of this paper enable practising engineers to make informed judgements in relation to the size of defects they would like to detect (and hence the associated risk this entails) together with the corresponding instrumentation layout required.

Utilizing nanotechnology to boost the reliability and determine the vertical load capacity of pile assemblies

Design Method Reliability Assessment from an Extended Database of Axial Load Tests on Piles Driven in Sand

Field Trials on Monotonic Behaviour of a Driven Pile at an Offshore Wind Farm in China

Experimental study on axial compression monitoring of pile foundation based on sensor-enabled piezoelectric geocable

Nanomaterials-Enabled Multifunctional Concrete And Structures

Field Study of Monotonic and Cyclic Lateral Behaviour of Piles in Soft Soils Improved with and Without Vacuum Preloading

Pile defect assessment using distributed temperature sensing: fundamental questions examined

Influence of Precast Microbial Reinforcement on Lateral Responses of Monopiles

Field Tests and Simplified Calculation Method for Static Drill Rooted Nodular Pile

Influence of Edge Scour on Lateral Responses of Monopiles with Precast Microbial Reinforcement

Distributed fiber optic sensing along driven ductile piles: Design, sensor installation and monitoring benefits

A Model Test for the Influence of Lateral Pressure on Vertical Bearing Characteristics in Pile Jacking Process Based on Optical Sensors.

Electric field–tunable self-sensing nanocomposites with aligned CNTs for in-situ pavement health monitoring: Electrodynamic alignment, sensor development, and performance validation

Study on pile-soil bonding condition based on transient shock response using piezoceramic sensors

Comparative analysis for strain response and life monitoring of composite using carbon-based nanosensors

Revealing the AC electromechanically coupled effects and stable sensitivity on the dielectric loss in CNT-based nanocomposite sensors

A Coatable, Light-Weight, Fast-Response Nanocomposite Sensor for Thein Situacquisition of Dynamic Elastic Disturbance: from Structural Vibration to Ultrasonic Waves

Study on new test technology of pile foundation bearing capacity

A Carbon Nanocomposite Material Used in the Physical Modelling of the Overburden Subsidence Process

Forecasting the Bearing Capacity of the Driven Piles Using Advanced Machine-Learning Techniques

EVALUATION AND ANALYSIS OF WORKING STATE OF ANTI-SLIDE PILE WITH BOTDR TECHNOLOGY