Abstract:Results are presented for modelling of the evaporation and magnetron sputter deposition of Zn(x)O(y) onto an O-terminated ZnO (0001¯) wurtzite surface. Growth was simulated through a combination of molecular dynamics (MD) and an on-the-fly kinetic Monte Carlo (otf-KMC) method, which finds diffusion pathways and barriers without prior knowledge of transitions. We examine the effects of varying experimental parameters, such as substrate bias, distribution of the deposition species and annealing temperature. It was found when comparing evaporation and sputtering growth that the latter process results in a denser and more crystalline structure, due to the higher deposition energy of the arriving species. The evaporation growth also exhibits more stacking faults than the sputtered growth. Post-annealing at 770 K did not allow complete recrystallization, resulting in films which still had stacking faults where monolayers formed in the zinc blende phase, whereas annealing at 920 K enabled the complete recrystallization of some films to the wurtzite structure. At the latter temperature atoms could also sometimes be locked in the zinc blende phase after annealing. When full recrystallization did not take place, both wurtzite and zinc blende phases were seen in the same layer, resulting in a phase boundary. Investigation of the various distributions of deposition species showed that, during evaporation, the best quality film resulted from a stoichiometric distribution where only ZnO clusters were deposited. During sputtering, however, the best quality film resulted from a slightly O rich distribution. Two stoichiometric distributions, one involving mainly ZnO clusters and the other involving mainly single species, showed that the distribution of deposition species makes a huge impact on the grown film. The deposition of predominantly single species causes many more O atoms at the surface to be sputtered or reflected, resulting in an O deficiency of up to 18% in the deposited film and therefore resulting in more stacking faults and phase boundaries. The methods used allow analysis of key mechanisms that occur during the growth process and give hints as to the optimum conditions under which complete crystalline layers can form.

Grain growth of ZnO nanocrystals synthesized in polyol medium with polyvinylpyrrolidone additives

Effect of Nucleation and Growth Kinetics on the Electrical and Optical Properties of Undoped ZnO Films

The growth of nanoscale ZnO films by pulsed-spray evaporation chemical vapor deposition and their structural, electric and optical properties

Effect of Reaction Temperature on Surface Morphology and Photoelectric Properties of ZnO Grown by Hydrothermal Method in Mixed Solvent

Enhanced Visible Light Response of ZnO Porous Thin Film by Post-Annealing Treatment

Poly(vinyl Pyrrolidone)-Assisted Hydrothermal Synthesis of Pb(Zr0.52Ti0.48)O3 Nanocrystals

Synthesis of Single-Crystalline Pb(Zr0.52Ti0.48)O-3 Nanocrystals by Hydrothermal Method

Thermal History Effect on the Nucleation of Oxygen Precipitates in Germanium Doped Cz-silicon Studied by High-Energy X-ray Diffraction

Fine-tuning the Synthesis of ZnO Nanostructures by an Alcohol Thermal Process.

Hydrothermal Synthesis of Well-Aligned ZnO Nanorod Arrays on Silicon

Preparation, Characterization, and Application of Zinc Oxide Nanoparticles by Sol-Gel Pyrrolysis Method: Influence of Annealing Temperature on Crystalline Phases

Grain Growth in (ga, Mn)-Codoped ZnO Ceramics

Thermal Dissipation Annealing for Crystallization of In‐Doped ZnO Films Deposited on Polyethylene Naphthalate Substrate without Substrate Deformation

Tempererature-Controlled Growth Of Zno Nanostructures: Branched Nanobelts And Wide Nanosheets

Effect of Annealing Temperature on Photoluminescence of ZnO/Graphene Nano-films Deposited by Sol-gel Method

Modelling the growth of ZnO thin films by PVD methods and the effects of post-annealing

Role of synthesis temperature in the formation of ZnO nanoparticles via the Sol-Gel process

Preparation and optical characteristics of ZnO films by chelating sol-gel method

Thermal annealing effect on optical properties of electrodeposited ZnO thin films

Growth Of Zno Crystals With Branched Spindles And Prismatic Whiskers From Zn-3(Oh)(2)V2o7 Center Dot H2o Nanosheets By A Hydrothermal Route

Study the characterization of ZnO and AZO films prepared by spray pyrolysis and the effect of annealing temperature