Abstract:Deep-sea mining lifting pump differs from conventional solid–liquid two-phase flow pump, due to the complex and ever-changing operating environment. It is more likely to experience emergency shutdowns and particle reflux, leading to pump blockage and ultimately causing damage to the lifting system. Research on the influence of particle characteristic parameters on pump reflux performance can provide theoretical support for the design of high-performance deep-sea mining lifting pumps. The impact of particle size on the reflux performance of a mining lifting pump during shutdown was investigated in this study. The coupling method of CFD–DEM (computational fluid dynamics–discrete element method) was employed to simulate the reflux of spherical particles with different sizes (5 mm, 6 mm, 7 mm), and comparative analysis was conducted to the reflux performance of particles with varying sizes in the lifting pump. The results indicate that particles tend to accumulate at the junction between the impeller and guide vane when reflux occurs in the lifting pump. As the particle size increases, the distribution of particles in the first and second-stage pump becomes denser, resulting in less smooth reflux inside the pump and noticeable clogging. Moreover, particle accumulation gradually extends into the flow channel of the impeller and guide vane. The average velocity of particles gradually decreases with larger particle sizes; this leads to an increase in the time it takes for particles to pass through the pump and a gradual deterioration in the reflux performance of the lifting pump. Further analysis indicates that the ratio of collision number between particles to the total number of collisions increases continuously with the increase in particle size. Additionally, as the particle size increases, the proportion of collisions between the particles and the second guide vane significantly increases.

Effect of Particle Factors on the Reflux and Blockage of a Deep‐Sea Six‐Stage Pump Based on CFD‐DEM (Adv. Theory Simul. 3/2024)

The effect of particle size on the reflux performance of the lifting pumps

Analysis and Experimental Research on Efficiency Characteristics of a Deep-Sea Hydraulic Power Source

Research of Particle Motion in a Two-Stage Slurry Transport Pump for Deep-Ocean Mining by the CFD-DEM Method

CFD-DEM analysis of internal flow characteristics in multistage deep-sea mining pumps

Impact of Particle Sizes on Flow Characteristics of Slurry Pump for Deep-Sea Mining

Studying particle transport characteristics in centrifugal pumps under external vibration using CFD-DEM simulation

Study on Wear Characteristics of a Guide Vane Centrifugal Pump Based on CFD–DEM

CFD-DEM investigation of centrifugal slurry pump with polydisperse particle feeds

Numerical Simulation of the Cavitation Characteristics of A Mixed-Flow Pump

Transient numerical simulation for solid-liquid flow in a centrifugal pump by DEM-CFD coupling

Numerical Simulation and Optimization of Internal Flow Field in the High Pressure Coal Conveying Pump Based on the Dynamic Mesh

Dynamic Simulation of a Seawater Plunger Pump

Investigation on wear induced by solid-liquid two-phase flow in a centrifugal pump based on EDEM-Fluent coupling method

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Numerical calculation and analysis of gas-liquid two-phase flow in a centrifugal multiphase pump for deep-sea mining

Influence on the Solid—Liquid Two-Phase Flow from Cross-Section Area of Slurry Pumps for Deep-Sea Mining

Research on Two-Phase Flow and Wear of Inlet Pipe Induced by Fluid Prewhirl in a Centrifugal Pump

Numerical analysis of internal complex flow in a deep - sea gas - liquid two - phase flow multistage centrifugal pump

Balance of Efficiency and Security-influence on Slurry Transport from the Diffusion of Flow Passages of a Deep-sea Mining Pump

Prediction of Abrasive and Impact Wear Due to Multi-Shaped Particles in a Centrifugal Pump via CFD-DEM Coupling Method