Abstract:Deep-sea mining lifting pump differs from conventional solid–liquid two-phase flow pump, due to the complex and ever-changing operating environment. It is more likely to experience emergency shutdowns and particle reflux, leading to pump blockage and ultimately causing damage to the lifting system. Research on the influence of particle characteristic parameters on pump reflux performance can provide theoretical support for the design of high-performance deep-sea mining lifting pumps. The impact of particle size on the reflux performance of a mining lifting pump during shutdown was investigated in this study. The coupling method of CFD–DEM (computational fluid dynamics–discrete element method) was employed to simulate the reflux of spherical particles with different sizes (5 mm, 6 mm, 7 mm), and comparative analysis was conducted to the reflux performance of particles with varying sizes in the lifting pump. The results indicate that particles tend to accumulate at the junction between the impeller and guide vane when reflux occurs in the lifting pump. As the particle size increases, the distribution of particles in the first and second-stage pump becomes denser, resulting in less smooth reflux inside the pump and noticeable clogging. Moreover, particle accumulation gradually extends into the flow channel of the impeller and guide vane. The average velocity of particles gradually decreases with larger particle sizes; this leads to an increase in the time it takes for particles to pass through the pump and a gradual deterioration in the reflux performance of the lifting pump. Further analysis indicates that the ratio of collision number between particles to the total number of collisions increases continuously with the increase in particle size. Additionally, as the particle size increases, the proportion of collisions between the particles and the second guide vane significantly increases.

Balance of Efficiency and Security-influence on Slurry Transport from the Diffusion of Flow Passages of a Deep-sea Mining Pump

Research of Particle Motion in a Two-Stage Slurry Transport Pump for Deep-Ocean Mining by the CFD-DEM Method

Impact of Particle Sizes on Flow Characteristics of Slurry Pump for Deep-Sea Mining

Hydraulic Optimization of Super-low Specific Speed Multistage Flameproof Submersible Pump with Inner Motor for Coal Mine

Influence on the Solid—Liquid Two-Phase Flow from Cross-Section Area of Slurry Pumps for Deep-Sea Mining

Finite element analysis of mixed transport pump in deep-sea mining under complicated conditions

Particle Anti-Accumulation Design at Impeller Suction of Deep-Sea Mining Pump and Evaluation by CFD-DEM Simulation

Optimizing Energy Efficiency in Deep-Sea Mining: A Study on Swirling Flow Transportation of Double-Size Mineral Particles

Motion characteristics of coarse particles in guide vanes of lifting pump for deep-sea mining

The Optimization of A Low Specific Speed Pipeline Pump

Prediction of Quasi - Fluid Performance in Different Volume Concentration of Deep Sea Mining

Characterization of the ellipsoidal particle motion in a two-stage lifting pump using CFD-DEM method

Research on the Unsteady Flow Characteristics of Solid–Liquid Two-Phase Flow in a Deep-Sea Mining Lift Pump and Model Experimental Verification

On the Axial Thrust and Hydraulic Performance of a Multistage Lifting Pump for Deep-Sea Mining

Experimental studies on passing characteristics of coarse particles in lifting pump of deep-sea mining system

CFD-DEM analysis of internal flow characteristics in multistage deep-sea mining pumps

Numerical Simulation of Particle Motion Trajectory in Lifting Pump for Deep-sea Mining

Study of the Two-Phase Flow and Wear of a Pump with Mixed-Size Particles

Liquid–solid Two-Phase Flow and Wear Characteristics in a Two-Stage Mixed-Transport Pump

The effect of particle size on the reflux performance of the lifting pumps

Numerical Investigation on Inclined Hydraulic Transport of Large Particles for Deepsea Mining