Research on Two-Phase Flow and Wear of Inlet Pipe Induced by Fluid Prewhirl in a Centrifugal Pump

Jilong Chen,Xing Chen,Wenjin Li,Yuhai Zheng,Yi Li

DOI: https://doi.org/10.3390/jmse12060950

IF: 2.744

2024-06-06

Journal of Marine Science and Engineering

Abstract:In deep-sea mining hydraulic lifting systems, centrifugal pumps are very important as power units. In the process of transportation, the fluid prewhirl phenomenon in the impeller inlet will lead to changes in the state of motion of the particles and fluid and cause the wear of the inlet pipe, which can lead to centrifugal pump failure in serious cases. In this paper, a numerical simulation of the centrifugal pump is carried out based on the CFD-DEM coupling method to analyze the influence of the prewhirl on the wear of the inlet pipe. The results show that the velocity streamline near the impeller inlet position changes significantly. The flow field velocity increases along the radial direction of the inlet pipe, and it has a maximum value at r/R = 0.98. The prewhirl flow pulls the particles to change their original motion direction, and the area where the particles are subjected to high fluid force is concentrated between 0.5 d/D and 1 d/D, about 0.015 to 0.018 N, resulting in the uneven distribution of particles. The high-wear area appears in the bottom-left area (specifically, L4, L9, and L13), and this is also the location of the largest cumulative force; the high-wear area shows a triangle. The collision energy loss of particles increases due to the influence of the prewhirl, which leads to an increase in wear.

oceanography,engineering, marine, ocean

What problem does this paper attempt to address?

### Problems Addressed by the Paper

This paper primarily investigates the impact of fluid pre-rotation phenomena on two-phase flow and wear in the inlet pipeline of a centrifugal pump. Specifically:

1. **Pre-rotation Phenomenon**: In deep-sea mining hydraulic lifting systems, the centrifugal pump is a crucial power unit. During transportation, the fluid pre-rotation at the impeller inlet can lead to changes in the motion state of particles and fluid, causing wear in the inlet pipeline, which can severely result in centrifugal pump failure.

2. **Numerical Simulation**: To analyze the impact of pre-rotation on inlet pipeline wear, the authors used the CFD-DEM coupling method for numerical simulation. The study found that pre-rotation significantly changes the streamlines near the impeller inlet, increases the flow field velocity along the radial direction of the inlet pipeline, and reaches its maximum at r/R=0.98.

3. **Particle Forces and Wear Distribution**: Pre-rotational flow causes particles to change their original motion direction, experiencing higher fluid forces (approximately 0.015 to 0.018 N) in the 0.5 d/D to 1 d/D region, leading to uneven particle distribution. High wear areas appear at specific positions in the lower left corner (such as L4, L9, and L13), which are also the places with the highest cumulative forces, showing a triangular wear distribution. Pre-rotation increases the energy loss from particle collisions, thereby exacerbating wear.

Through the above research, this paper aims to provide theoretical support for the design optimization of solid-liquid mixed centrifugal pumps in deep-sea mining.