Abstract:The clearance leakage flow of liquid-ring pump has complex spatiotemporal distribution characteristics, and it has severe negative impact on its performance. In order to suppress the axial blade tip leakage flow of liquid-ring pump, the spatiotemporal distribution characteristics of leakage flow was analyzed in detail by numerical simulation method. The composite tip of winglet and squealer was introduced to the liquid-ring pump, and its suppression mechanism was analyzed. The RNG k-ε turbulence model and VOF multiphase flow model were selected to simulate transient flow in liquid-ring pump. The results show that the leakage flow in the suction zone gradually decreases from hub to rim, and the leakage flow intensity gradually increases along the rotation direction of the impeller. The gas leakage velocity of compression zone is the highest, and the leakage flow intensity gradually increases along the rotation direction of the impeller. In the exhaust zone, the reverse leakage flow forms near the hub, which flows from the clearance suction side to the pressure side, and the leakage flow intensity gradually decreases from the hub to the rim. Near the rim, the leakage flow direction changes, flowing from pressure side to suction side. In the transition zone, as the impeller flow passage approaching suction zone gradually, the pressure decreases continuously. The pressure on the clearance suction side is greater than that of the pressure side, and the reverse leakage flow forms near the hub. The composite tip blade of winglet and squealer not only lengthens the clearance channel but also blocks the clearance by the pressure side squealer corner vortex and the squealer vortex, thus the leakage flow was effectively suppressed. To some extend the composite tip can suppress the leakage flow, the vacuum values are improved by 3.5%, 3.9%, and 5.3% under different conditions respectively.

Motion characteristics and wear analysis of particles in the clearances of a twin-screw pump

Particle distribution and two-phase flow characteristics of twin-screw pump during solid-liquid transfer

Investigation on wear induced by solid-liquid two-phase flow in a centrifugal pump based on EDEM-Fluent coupling method

Experimental and Numerical Studies on Erosion Damage in Damping Holes on the Valve Plate of an Axial Piston Pump

Study on the Effects of the Wear-Rings Clearance on the Solid-Liquid Two-Phase Flow Characteristics of Centrifugal Pumps

Study on Wear Characteristics of a Guide Vane Centrifugal Pump Based on CFD–DEM

Centrifugal pump wear for solid–liquid two-phase flows based on computational fluid dynamics–discrete element method coupling

Study on the erosion characteristics of mixed-flow pumps under forced action of solid particles

Analysis of Tip Clearance Effect on the Transportation Characteristics of a Multiphase Rotodynamic Pump Based on the Non-Uniform Bubble Model

Experimental Research on the Movement Rule of Solid Particles in Centrifugal Pump

Performance analysis of embedded tri-screw pump based on computational fluid dynamics

THE TRANSITION OF WEAR AND LEAKAGE CHARACTERISTICS OF THE CYLINDER BLOCK/VALVE PLATE INTERFACE IN A WIDE RANGE OF OPERATING CONDITIONS

A Study of the Relationship between Sand Movement and Flow Field Distribution and Wear Causes in a Multiphase Pump

Investigation on Structural Optimization of Anti-Overturning Slipper of Axial Piston Pump

Numerical study on flow and wear characteristics of dense fine particle solid–liquid two-phase flow in centrifugal pump

Solid-liquid two-phase flow and wear analysis in a large-scale centrifugal slurry pump

Numerical simulation of solid-liquid two-phase flow in a centrifugal pump with different wear blades degree

Research on Two-Phase Flow and Wear of Inlet Pipe Induced by Fluid Prewhirl in a Centrifugal Pump

The spatiotemporal distribution characteristics analysis and suppression of the axial tip clearance leakage flow for the liquid-ring vacuum pump

Investigation of hydrodynamic lubricant film breakdown between the journal and bearing in a high-speed coolant pump of electric vehicles

Research on prediction methods for eccentric wear of the slipper pair in axial piston pumps and lubrication performance analysis