Abstract:Abstract Integrated femtosecond pulse and frequency comb sources are critical components for a wide range of applications, including optical atomic clocks, microwave photonics, spectroscopy, optical wave synthesis, frequency conversion, communications, lidar, optical computing8, and astronomy9. The leading approaches for on-chip pulse generation rely on mode locking inside microresonator with either third-order nonlinearity10 or with semiconductor gain. These approaches, however, are limited in noise performance, wavelength tunability and repetition rates. Alternatively, sub-picosecond pulses can be synthesized without mode-locking, by modulating a continuous-wave (CW) single-frequency laser using a cascade of electro-optic (EO) modulators. This method is particularly attractive due to its simplicity, robustness, and frequency-agility but has been realized only on a tabletop using multiple discrete EO modulators and requiring optical amplifiers (to overcome large insertion losses), microwave amplifiers, and phase shifters. Here we demonstrate a chip-scale femtosecond pulse source implemented on an integrated lithium niobate (LN) photonic platform, using cascaded low-loss electro-optic amplitude and phase modulators and chirped Bragg grating, forming a time-lens system. The device is driven by a CW distributed feedback (DFB) chip laser and controlled by a single CW microwave source without the need for any stabilization or locking. We measure femtosecond pulse trains (520 fs duration) with a 30-GHz repetition rate, flat-top optical spectra with a 10-dB optical bandwidth of 12.6 nm, individual comb-line powers above 0.1 milliwatt, and pulse energies of 0.54 picojoule. Our results represent a tunable, robust and low-cost integrated pulsed light source with CW-to-pulse conversion efficiencies an order of magnitude higher than achieved with previous integrated sources. Our pulse generator can find applications from ultrafast optical measurement to networks of distributed quantum computers.

CPA-ready femtosecond pulses at 1 MHz from a custom recycled output Mamyshev oscillator

High Pulse Repetition Frequency Fiber-Coupled Laser-Diode Module

Multi-megawatt pulses at 50 MHz from a single-pump Mamyshev oscillator gain-managed amplifier laser

396 MHz CPA femtosecond laser system based on a single crystal fiber rod-type amplifier

10-µJ-level femtosecond pulse generation in the erbium CPA fiber source with microstructured hollow-core fiber assisted delivery and nonlinear frequency conversion

Generation Of Ultra-Stable 50-Fs Pulses Directly From An Er-Doped Fiber Oscillator

High Energy, Monolithic Fiber Femtosecond Lasers

Over 80 nJ Sub-100 fs All-Fiber Mamyshev Oscillator

Femtosecond Pulse Generation via an Integrated Electro-Optic Time Lens

Direct Frequency-Mode-Stable Laser Amplification at Terahertz Burst Rates

Pulses of 32 mJ and 158 fs at 20-kHz repetition rate from a spatiotemporally combined fiber laser system

112-Μj 180-Fs Pulses at 1-Khz Repetition Rate from Yb-Doped Laser Based on Strictly All-Fiber CPA Structure

72-fs Er-doped Mamyshev Oscillator

Integrated femtosecond pulse generator on thin-film lithium niobate

High-Power GHz Burst-Mode All-Fiber Laser System with Sub 300 fs Pulse Duration

Wavelength-Tunable Chirped Pulse Amplification System (1720 nm–1800 nm) Based on Thulium-Doped Fiber

High-contrast Ultrabroadband Frontend Source for High Intensity Few-Cycle Lasers

Ultra-broadband, few cycle pulses directly from a Mamyshev fiber oscillator

Generation of 10 GHz 2 Ps Short Laser Pulses Using an Electroabsorption Modulator and Two-Stage Compression

Femtosecond pulse amplification on a chip

A large dispersion-managed monolithic all-fiber chirped pulse amplification system for high-energy femtosecond laser generation