Abstract:The wide bandgap, high-breakdown electric field, and high carrier mobility makes GaN an ideal material for high-power and high-frequency electronics applications, such as wireless communication and radar systems. However, the performance and reliability of GaN-based high-electron-mobility transistors (HEMTs) are limited by the high channel temperature induced by Joule heating in the device channel. Integration of GaN with high thermal conductivity substrates can improve the heat extraction from GaN-based HEMTs and lower the operating temperature of the device. However, heterogeneous integration of GaN with diamond substrates presents technical challenges to maximize the heat dissipation potential brought by the ultrahigh thermal conductivity of diamond substrates. In this work, two modified room-temperature surface-activated bonding (SAB) techniques are used to bond GaN and single-crystal diamond. Time-domain thermoreflectance (TDTR) is used to measure the thermal properties from room temperature to 480 K. A relatively large thermal boundary conductance (TBC) of the GaN/diamond interfaces with a ∼4 nm interlayer (∼90 MW/(m<sup>2</sup> K)) was observed and material characterization was performed to link the interfacial structure with the TBC. Device modeling shows that the measured TBC of the bonded GaN/diamond interfaces can enable high-power GaN devices by taking full advantage of the ultrahigh thermal conductivity of single-crystal diamond. For the modeled devices, the power density of GaN-on-diamond can reach values ∼2.5 times higher than that of GaN-on-SiC and ∼5.4 times higher than that of GaN-on-Si with a maximum device temperature of 250 °C. Our work sheds light on the potential for room-temperature heterogeneous integration of semiconductors with diamond for applications of electronics cooling, especially for GaN-on-diamond devices.

Near-junction microfluidic cooling for GaN HEMT with capped diamond heat spreader

Advancing Cryogenic Electronic Cooling: A Case Study on Embedded Manifold Microchannels in Micromachined Joule-Thomson Coolers

Active Thermal Management of GaN-on-SiC HEMT with Embedded Microfluidic Cooling

Suppressing Temperature Rise in AlGaN/GaN HEMT with Graphene Layers

Thermal Management of GaN HEMT Devices Using Subcooled Flow Boiling in an Embedded Manifold Microchannel Heat Sink

Optimization of Embedded Cooling for Hotspots Based on Compound Plate Thermal Spreading Model

Near-junction heat spreaders for hot spot thermal management of high power density electronic devices

Interfacial Thermal Conductance across Room-Temperature-Bonded GaN/Diamond Interfaces for GaN-on-Diamond Devices

A GaN HEMT Integrated Power Module with Silver Sintering Processes

Enhanced performance of Ku-band GaN MMIC PA through embedded microfluidic cooling

Integration of polycrystalline diamond heat spreader with AlGaN/GaN HEMTs using a dry/wet combined etching process

Simulations of Diamond Heat Spreader for the Thermal Management of Gan Hemt

Thermal Analysis of Flip-Chip Bonding Designs for GaN Power HEMTs with an On-Chip Heat-Spreading Layer

A Novel Strategy for GaN-on-Diamond Device with a High Thermal Boundary Conductance

Numerical simulation and microchannels parameters optimization for thermal management of GaN HEMT devices

A Compact Double-Sided Cooling 650V/30A GaN Power Module With Low Parasitic Parameters

A 3-D Integrated Power Module of GaN HEMTs Based on Silver Sintering Processes

Enhanced Heat Dissipation of GaN RF Devices Based on Double-diamond Structure

High Thermal Boundary Conductance across Bonded Heterogeneous GaN-SiC Interfaces

Diamond as the heat spreader for the thermal dissipation of GaN-based electronic devices

Thermal Performance Improvement of AlGaN/GaN HEMTs Using Nanocrystalline Diamond Capping Layers