Abstract:Increasing cuttings bed height is a serious concern during extended-reach well drilling. In order to predict and prevent cuttings bed height increase, it is essential to study how the critical parameters influence the cuttings transport, especially the drill pipe rotation effects on the cuttings transport process. In conventional models for cuttings transport, the dynamic behavior of particles due to drill pipe rotation is neglected or empirically simplified. This paper presents a coupled Computational Fluid Dynamics and Discrete Element Method (CFD–DEM) approach to simulate the cuttings transport considering the dynamic collision process. The fluid phase is treated as an Eulerian continuum and described by CFD method. The cutting phase is modeled by DEM using a soft sphere approach for the particle collision dynamic. The continuum and dispersed phases are strongly coupled via the interaction forces such as the drag force, lift force and pressure gradient force, which is taken into account in the developed CFD–DEM model. The model takes into account the collisions of cutting–cutting, cutting–drill pipe and cutting–wall. Simulations are carried out for a number of laboratory-scale configurations, showing good agreement with experiment data reported in literature. The numerical simulations show that the drill pipe rotation builds cuttings presented in non-symmetric distribution along the hole and significantly decreases the cutting volume concentration at the medium and high fluid inlet velocities and lower range of drill pipe speeds. There is no additional contribution of drill pipe rotation after reaching a critical speed at high fluid inlet velocities. At low fluid inlet velocities, increasing the drill pipe rotation from 0 to 80rpm dose not significantly affect the cuttings concentration; although an increase in drill pipe rotation speed from 100 to 120rpm provided a remarkable improvement. Furthermore, at low inlet fluid velocities and horizontal inclinations up to 40°, drill pipe rotation can significantly decrease the cuttings concentration. The effect of drill pipe rotation on decreasing the cuttings concentration is almost negligible at high inlet fluid velocities for any inclination.

Effect of drill pipe rotation on gas-solid flow characteristics of negative pressure pneumatic conveying using CFD-DEM simulation

Coal particle transport behavior in a rotating drill pipe used for negative pressure pneumatic conveying

Numerical investigation of the particle flow behaviors in a fluidized-bed drum by CFD-DEM

Numerical simulations on the flow regime characteristics of horizontal pneumatic conveying using CFD-DEM

CFD-DEM Simulation of Reverse Circulation Pneumatic Cuttings Removal during Coal Seam Drilling

CFD–DEM Simulation of Pneumatic Conveying in a Horizontal Channel

Investigating the Flow of Rod-Like Particles in a Horizontal Rotating Drum Using DEM Simulation

Analysis of gas-solid flow characteristics in intricate pipelines

Numerical investigation of flow patterns in cuttings transport for extended-reach horizontal wells with rotation drillpipe

A Numerical Simulation of the Coal Dust Migration Law in Directional Air Drilling in a Broken Soft Coal Seam

CFD-DEM Simulation of Flow and Mixing Behavior in Downers with Different Entrance Structures

Modelling of the Flow of Ellipsoidal Particles in a Horizontal Rotating Drum Based on DEM Simulation

Comparison of computational fluid dynamics–discrete element method and discrete element method simulations for a screw conveyor

Numerical simulation of dense-phase pneumatic conveying in vertical pipe for gasifier

Numerical Simulation of Hydrodynamics in Downers Using a CFD–DEM Coupled Approach

Experimental study on the solid velocity in horizontal dilute phase pneumatic conveying of fine powders

CFD-DEM Modelling of Hydraulic Conveying of Solid Particles in a Vertical Pipe

CFD–DEM approach to investigate the effect of drill pipe rotation on cuttings transport behavior

Design and Experimental Study of Negative Pressure Spiral Separation and Reduction Device for Drilling Holes

CFD–DEM method is used to study the multi-phase coupling slag discharge flow field of gas-lift reverse circulation in drilling shaft sinking

Numerical Simulation on Gas-Solid Two-Phase Flow in Horizontal Pneumatic Conveying Pipe Based on DPM Model