Abstract:Accurate knowledge of the rotor position is essential for the control of brushless DC motors (BLDCM). Any deviation in this identification can cause fluctuations in motor current and torque, increase noise, and lead to reduced motor efficiency. This paper focused on a BLDCM equipped with a three-phase binary Hall sensor. Based on the principle of minimum deviation, this paper estimated the relative installation offset between the Hall sensors. It also provided a clear method for ideal phase commutation position recognition and eliminated the Hall sensor installation position deviation. The proposed pre-calibration method identified and eliminated the offset of the permanent magnet poles, the delay time caused by the Hall signal conditioning circuit, and the offset of the sensor signal identification due to armature response under different loads. Based on the pre-calibration results, a correction strategy for correcting the rotor position information of BLDCMs was proposed. This paper presented a self-adaptive position information prediction algorithm based on the Sage-Husa method. This filters out rotor position information deviations that are not eliminated in pre-calibration. Experimental results on a hydrogen circulation pump motor showed that, after the pre-calibration method was adopted, the Mean Square Error (MSE) of motor speed fluctuations decreased by 92.0%, motor vibration was significantly reduced, average phase current decreased by 62.8%, and the efficiency of the hydrogen circulation pump system was significantly improved. Compared to the traditional KF prediction algorithm, the Sage-Husa adaptive position information prediction algorithm reduced the speed fluctuation during the uniform speed operation stage and speed adjustment stage, the speed curve overshoot, and the commutation time deviation throughout the process by 44.8%, 56.0%, 54.9%, and 14.7%, respectively. This indicates a higher disturbance rejection ability and a more accurate and stable prediction of the commutation moment.

Effect of Hall Errors on Current and Rotor Position of Robot Joint Motors

Influence of Stator Asymmetry on Cogging Torque of Permanent Magnet Brushless Machines

Analysis and Suppression of Rotor Eccentricity Effects on Fundamental Model Based Sensorless Control of Permanent Magnet Synchronous Machine

Modeling and Evaluation of Stator and Rotor Faults for Induction Motors

Analysis of torque ripple and torsional vibration considering Hall mounting errors in permanent magnet synchronous motors for light EVs

An Improved Rotor Position Estimation Method for PMSM Using Low-Resolution Hall-Effect Sensors

Comparative Performance Evaluation of Hall Effect Sensorless Control Options in Permanent Magnet Brushless DC Motor Drives

Optimization of Hall Position Sensor for Permanent Magnet Synchronous Linear Motors

An improved rotor position estimation in PMSM with low-resolution hall-effect sensors

Research on Rotor Position Estimation of PMSM Based on Hall Position Sensor

Analysis and Detection of Rotor Eccentricity in Permanent Magnet Synchronous Machines Based on Linear Hall Sensors

Position Reconstruction of Brushless DC Motor Based on Hall-rotating-vector Harmonic-decoupling Method

An Improved PMSM Rotor Position Sensor Based on Linear Hall Sensors

An Improved Rotor Position and Speed Estimation Method for PMSM with Hall Sensors

Sinusoidal commutation of a high-speed PM synchronous motor with one discrete Hall sensor

A Sage-Husa Prediction Algorithm-Based Approach for Correcting the Hall Sensor Position in DC Brushless Motors

A Hall Sensor-Based Position Measurement with On-Line Model Parameters Computation for Permanent Magnet Synchronous Linear Motor

DC Drift Error Mitigation Method for Three-Phase Current Reconstruction with Single Hall Current Sensor

Online Detection of Rotor Eccentricity and Demagnetization Faults in PMSMs Based on Hall-Effect Field Sensor Measurements

Analysis of Inter-Turn Short-Circuit Faults in Brushless DC Motors Based on Magnetic Leakage Flux and Back Propagation Neural Network

Error Compensation of Linear Hall Based Position Detection for Tubular Permanent Magnetic Linear Synchronous Motor