Abstract:Accurate knowledge of the rotor position is essential for the control of brushless DC motors (BLDCM). Any deviation in this identification can cause fluctuations in motor current and torque, increase noise, and lead to reduced motor efficiency. This paper focused on a BLDCM equipped with a three-phase binary Hall sensor. Based on the principle of minimum deviation, this paper estimated the relative installation offset between the Hall sensors. It also provided a clear method for ideal phase commutation position recognition and eliminated the Hall sensor installation position deviation. The proposed pre-calibration method identified and eliminated the offset of the permanent magnet poles, the delay time caused by the Hall signal conditioning circuit, and the offset of the sensor signal identification due to armature response under different loads. Based on the pre-calibration results, a correction strategy for correcting the rotor position information of BLDCMs was proposed. This paper presented a self-adaptive position information prediction algorithm based on the Sage-Husa method. This filters out rotor position information deviations that are not eliminated in pre-calibration. Experimental results on a hydrogen circulation pump motor showed that, after the pre-calibration method was adopted, the Mean Square Error (MSE) of motor speed fluctuations decreased by 92.0%, motor vibration was significantly reduced, average phase current decreased by 62.8%, and the efficiency of the hydrogen circulation pump system was significantly improved. Compared to the traditional KF prediction algorithm, the Sage-Husa adaptive position information prediction algorithm reduced the speed fluctuation during the uniform speed operation stage and speed adjustment stage, the speed curve overshoot, and the commutation time deviation throughout the process by 44.8%, 56.0%, 54.9%, and 14.7%, respectively. This indicates a higher disturbance rejection ability and a more accurate and stable prediction of the commutation moment.

Error Compensation of Linear Hall Based Position Detection for Tubular Permanent Magnetic Linear Synchronous Motor

Optimization of Hall Position Sensor for Permanent Magnet Synchronous Linear Motors

Position Detection and Error Compensation for Tubular PMLSM with Hall-effect Sensors

Research on Permanent Magnet Linear Synchronous Motor Position Sensorless Control System

Analysis and Compensation of Hall Sensor-Based Position Detection Errors in TPMSLM

An Improved Position Detection Method for Permanent Magnet Linear Motor Using Linear Hall Sensors

Analog-Hall-Sensor-Based Position Detection Method With Temperature Compensation For Permanent-Magnet Linear Motor

A Hall Sensor-Based Position Measurement with On-Line Model Parameters Computation for Permanent Magnet Synchronous Linear Motor

Research on the Position Error Compensation of Linear Motor

Mover Position Detection For Pmtlm Based On Linear Hall Sensors Through Ekf Processing

A Parameter Adaptive Feedforward Compensation Method for SPMSM Using Hall-Effect Sensor

An improved rotor position estimation in PMSM with low-resolution hall-effect sensors

Accurate Motion Control of Linear Motors with Adaptive Robust Compensation of Nonlinear Electromagnetic Field Effect

Position Detecting for the Air-Cored TPMLSM with Linear Hall-effect Sensors

An Improved Rotor Position Estimation Method for PMSM Using Low-Resolution Hall-Effect Sensors

An Improved PMSM Rotor Position Sensor Based on Linear Hall Sensors

Research on Rotor Position Estimation of PMSM Based on Hall Position Sensor

An Improved Rotor Position and Speed Estimation Method for PMSM with Hall Sensors

Position Estimation Accuracy Improvement Based on Accurate Modeling of Self-Sensing Active Magnetic Bearings

Online Demagnetization Fault Recognition for Permanent Magnet Motors Based on the Hall-Effect Analog Sampling

A Sage-Husa Prediction Algorithm-Based Approach for Correcting the Hall Sensor Position in DC Brushless Motors