Abstract:The model proposed in this study was based on the assumption that the biomass attached to the anode served as biocatalysts for microbial fuel cell (MFC) exoelectrogenesis, and this catalytic effect was quantified by the exchange current density of anode. By modifying the Freter model and combining it with the Butler–Volmer equation, this model could adequately describe the processes of electricity generation, substrate utilization, and the suspended and attached biomass concentrations, at both batch and continuous operating modes. MFC performance is affected by the operating variables such as initial substrate concentration, external resistor, influent substrate concentration, and dilution rate, and these variables were revealed to have complex interactions by data simulation. The external power generation and energy efficiency were considered as indices for MFC performance. The simulated results explained that an intermediate initial substrate concentration (about 100 mg/L under this reactor configuration) needed to be chosen to achieve maximum overall energy efficiency from substrate in the batch mode. An external resistor with the value approximately that of the internal resistance, boosted the power generation, and a resistor with several times of that of the internal resistance achieved better overall energy efficiency. At continuous mode, dilution rate significantly impacted the steady-state substrate concentration level (thus substrate removal efficiency and rate), and attached biomass could be fully developed when the influent substrate concentration was equal to or higher than 100 mg/L at any dilution rate of the tested range. Overall, this relatively simple model provided a convenient way for evaluating and optimizing the performance of MFC reactors by regulating operating parameters.

Kinetic modeling for miniaturize single-chambered microbial fuel cell: effects of biochemical reaction on its performance

Optimization of operating conditions of miniaturize single chambered microbial fuel cell using NiWO4/graphene oxide modified anode for performance improvement and microbial communities dynamics

A simple microbial fuel cell model for improvement of biomedical device powering times

Ensemble Engineering and Statistical Modeling for Parameter Calibration Towards Optimal Design of Microbial Fuel Cells

Optimization of Microbial a Fuel Cell with Linear Sweep Voltammetry and Microfluidics

Modelling Microbial Fuel Cells Using Lattice Boltzmann Methods

Multiparameter optimization of microbial fuel cell outputs using linear sweep voltammetry and microfluidics

Modeling and experimental investigation of the effect of carbon source on the performance of tubular microbial fuel cell

Modelling the impact of operating mode and electron transfer mechanism in microbial fuel cells with two-species anodic biofilm

Effect of Electricity on Microbial Community of Microbial Fuel Cell Simultaneously Treating Sulfide and Nitrate

Novel Analytical Microbial Fuel Cell Design for Rapid in Situ Optimisation of Dilution Rate and Substrate Supply Rate, by Flow, Volume Control and Anode Placement

Intermittent Contact of Fluidized Anode Particles Containing Exoelectrogenic Biofilms for Continuous Power Generation in Microbial Fuel Cells

Performance Assessment of Multi-Electrodes Reactors for Scaling-up Microbial Fuel Cells

Modeling Power Generation and Energy Efficiencies in Air-Cathode Microbial Fuel Cells Based on Freter Equations

Scale-up of Membrane-Free Single-Chamber Microbial Fuel Cells

Assessing the Performance of Continuous-Flow Microbial Fuel Cells and Membrane Electrode Assembly with Electrodeposited Mn Oxide Catalyst

Modification of carbon based cathode electrode in a batch-type microbial fuel cells

Prediction and Optimization of the Performance in an Osmotic Microbial Fuel Cell for Water Purification and Bioelectricity Production Using a Developed Process Model

Investigating the influence of Saccharomyces cerevisiae on microbial fuel cell performance through bioelectrochemical and biochemical approaches under varied operating conditions

Modelling the cathodic reduction of 2,4-dichlorophenol in a microbial fuel cell

Role of electrode and proton exchange membrane configurations on microbial fuel cell performance toward bioelectricity generation integrated wastewater treatment