Abstract:This paper presents the design of a subsampling wideband 500MS/s 12Bit successive-approximation-register (SAR) analog-to-digital converter (ADC) with sub-2 radix split-capacitor array (SCA). The presented ADC is designed as a sub-ADC for a sample-and-hold-less (SAH-less) 8GS/s time-interleaved (TI) ADC. In addition to the required 16 ADC channels, two additional SAR lanes enable pseudorandom binary sequence (PRBS)-driven channel scrambling. A 1.81 radix is used to achieve 12Bit settling accuracy withing 70ps. Extra scaling capacitors in the SCA enable SAR reference voltage levels near the supply rails, significantly reducing the SCA switch sizes. The necessity of a comparator latch reset phase is eliminated at the cost of higher comparator power consumption by the adoption of a loop-unrolled comparator improving the SAR loop timing. Top-plate charge kickback into the input buffer, a challenge that occurs within TI ADCs, is largely eliminated by implementing an additional reset phase within the SAR algorithm and the use of a boosted input T-switch. SCA and time-interleaved channel mismatch effects are addressed by calibrating each sub-ADC to an extra reference-ADC. The industry grade ADC design, achieves a spurious free dynamic range (SFDR) of 72dB and signal to noise and distortion ratio (SNDR) of 54dB across the entire 4GHz frequency range. Designed in a 28nm CMOS process, each sub-ADC consumes 33mW from 1.8V and 1V. The input buffer frontend uses supply voltages of 2.5V and -1.3V. The overall power consumption of the overall TI ADC is 3W.

A 12-bit High-Speed Time-Interleaved Pipelined Asynchronous Successive-Approximation ADC in 22-nm FDSOI CMOS

A 16-Bit 2.5-Ms/s SAR ADC with On-Chip Foreground Calibration

A 14-Bit 500-Ms/s Pipelined-SAR ADC in 28-Nm CMOS with Foreground and Background Calibration

A 12-Bit 2.32gs/s Pipelined/sar Hybrid ADC with a High-Linearity Input Buffer.

A 16-Channel 12-Bit Rail-to-rail Successive Approxmation Register ADC for AFEs

Design of an 8-Channel 12bits 1MSPS SAR ADC

A 1.5 Mw 68 Db SNDR 80 Ms/s 2<formula Formulatype="inline"> <tex Notation="TeX">$\times$</tex></formula> Interleaved Pipelined SAR ADC in 28 Nm CMOS

A 12-bit 100-MSps pipelined-SAR ADC with a time-interleaved second-stage

A 12-bit 1.1GS/s Pipelined-SAR ADC With Adaptive Inter-Stage Redundancy in 28 nm CMOS

A 68.5 Db-Sndr, 12.4-Fj/conv.-step, 100-Ms/s Pipelined-Sar ADC with PVT-enhanced Circuitry

A 12-Bit 1.5-Gs/s Single-Channel Pipelined SAR ADC with a Pipelined Residue Amplification Stage

A Low-Power 12-Bit 2gs/S Time-Interleaved Pipelined-Sar Adc In 28nm Cmos Process

A 150 MS/s 10-Bit CMOS Pipelined Subranging ADC with Time Constant Reduction Technique.

A 12 Bit 500 MS/s Sub-2 Radix SAR ADC for a Time-Interleaved 8 GS/s ADC in 28 nm CMOS

A 12-Bit 625 MS/s Time-interleaved Pipelined ADC

A 7-Bit 3.8-Gs/s 2-Way Time-Interleaved 4-Bit/cycle SAR ADC 16× Time-Domain Interpolation in 28-Nm CMOS

A 400-Ms/s 12-Bit Voltage-Time Hybrid ADC with a Ping-Pong SAR TDC for Speed Enhancement.

A Novel Redundant Pipelined Successive Approximation Register Adc

A 12bit 800ms/s Time-Interleaving Pipeline ADC in 65nm CMOS

A calibration-free 10.7 fJ/conv.-step 12-bit 120-MS/s pipelined SAR ADC in 40nm CMOS

A 12-Bit 20ms/s Asynchronous SAR ADC