Abstract:Purpose: To determine the effect of 2 extra-articular reconstructions on pivot-shift rotational stability and tibial internal rotation as a basis for clinical recommendations. Methods: A robotic simulator tested 15 cadaver knees. Group 1 (anterior cruciate ligament [ACL] cut) underwent ACL bone-patellar tendon-bone reconstruction followed by sectioning the anterolateral structures and an extra-articular, manual-tension iliotibial band (ITB) tenodesis. Group 2 (ACL intact) tested the rotational stabilizing effect of a low-tension ITB tenodesis before and after sectioning the anterolateral ligament/ITB structures. Lateral and medial tibiofemoral compartment translations and internal-external tibial rotations were measured under Lachman, 5N·m tibial rotation, and 2 pivot-shift simulations using 4-degree-of-freedom loading. Statistical equivalence was defined within 2 mm tibiofemoral compartment translation and 2° tibial rotation at P < .05. Results: The bone-patellar tendon-bone ACL reconstruction (group 1) restored pivot-shift lateral compartment translation within 0.7 mm (95% confidence interval [CI], -0.6 to 1.9; P = .70) of normal. The internal rotation limit was not affected by ACL sectioning or reconstruction. After anterolateral ligament/ITB sectioning there was no change in pivot-shift lateral compartment translation, however internal rotation increased 2.9° (95% CI, 0.6-5.2; P = .99) at 90° flexion. The manual-tension ITB tenodesis (fixated 13-22 N tension) decreased pivot-shift lateral compartment translation 4.8 mm (95% CI, 1.4-8.1; P = .99) and internal rotation by 21.9° (95% CI, 13.2-30.6; P = .99) at 90° flexion. The ACL forces decreased 45.8% in the pivot-shift test. In group 2 knees, with the ACL intact, the anterolateral ligament/ITB sectioning had no effect on pivot-shift translations; however, the internal rotation limit increased by 4.3° (95% CI, 1.9-6.8; P = .99) at 60° flexion. The low-tension ITB tenodesis (fixated 8.9 N tension) had no effect on pivot-shift translations and corrected internal tibial rotation with a mild overconstraint of 4.2° (95% CI, 1.9-6.8; P = .99) at 60° flexion. Conclusions: A low-tension ITB tenodesis, fixated at neutral tibial rotation to avoid constraining internal tibial rotation, has no effect in limiting abnormal pivot-shift subluxations. Clinical relevance: A low-tension ITB tenodesis has limited clinical utilization as the pivot-shift subluxations are not affected, assuming appropriate tensioning to not overconstrain internal tibial rotation.

Effect of Posterior Cruciate Ligament Resection on Gap Balancing in Robot‐assisted Total Knee Arthroplasty

The Disproportionate Increase of the Intraoperative Flexion and Extension Gap Space after Posterior Cruciate Ligament Resection in Total Knee Arthroplasty

Effect of Posterior Cruciate Ligament on Knee Pressure and Gap Measured by an Electronic Sensor During Total Knee Arthroplasty

Criteria for preserving posterior cruciate ligament depending on intra-operative gap measurement in total knee replacement

Biomechanical role of posterior cruciate ligament in total knee arthroplasty: A finite element analysis

Effect of surgical parameters on the biomechanical behaviour of bicondylar total knee endoprostheses – A robot-assisted test method based on a musculoskeletal model

Comparative analysis and validation of posterior cruciate ligament management in mobile-bearing total knee arthroplasty: Meta-analysis and animal study

Effect of tibia‐first, restricted functional alignment technique on gap width changes, and component positioning in robotic arm‐assisted total knee arthroplasty

Effects of the posterior cruciate ligament and tibia insert thickness on tibiofemoral joint pressure in total knee arthroplasty: a cadaveric study

Posterior Cruciate Ligament Preservation versus Posterior Cruciate Ligament Sacrifice: Comparing Patient Outcomes in Medial Congruent Total Knee Arthroplasty

Adjusting Insert Thickness and Tibial Slope Do Not Correct Internal Tibial Rotation Loss Caused by PCL Resection: In Vitro Study of a Medial Constraint TKA Implanted with Unrestricted Calipered Kinematic Alignment

Posterior tibial slope impacts intraoperatively measured mid-flexion anteroposterior kinematics during cruciate-retaining total knee arthroplasty

Load-Dependent Characteristics of Cruciate-Retaining and Posterior-Stabilized Total Knee Arthroplasty: A Biomechanical Study

Effect of Joint Line Elevation after Posterior-stabilized and Cruciate-retaining Total Knee Arthroplasty on Clinical Function and Kinematics

Two Different Knee Rotational Instabilities Occur With Anterior Cruciate Ligament and Anterolateral Ligament Injuries: A Robotic Study on Anterior Cruciate Ligament and Extra-articular Reconstructions in Restoring Rotational Stability

Three-Dimensional Motion Analysis After TKA: The Effect of PCL Resection

Functionally aligned total knee arthroplasty: A lateral flexion laxity up to 6 mm is safe!

Influence of posterior cruciate ligament tension on tibiofemoral and patellofemoral joint contact mechanics in cruciate-retaining total knee replacement: a combined musculoskeletal multibody and finite-element simulation

THE BIOMECHANICAL STUDY OF DIFFERENT POSTERIOR CRUCIATE LIGAMENT RECONSTRUCTION TECHNIQUES

Retention of the posterior cruciate ligament stabilizes the medial femoral condyle during kneeling using a tibial insert with ball-in-socket medial conformity

Intraoperative knee kinematics measured by computer‐assisted navigation and intraoperative ligament balance have the potential to predict postoperative knee kinematics