Abstract:Tibio‐femoral contact forces calculated by FEA models agree with those of the inverse dynamic analysis method. TKA could effectively restore tibio‐femoral contact force distribution. The gait changes correspond to changes of contact force distribution. Objective To assess the tibio‐femoral contact forces before and after total knee arthroplasty (TKA) in patients with knee osteoarthritis (KOA) by three‐dimensional (3D) finite element analysis (FEA) models and gait analysis. Methods Two hospitalized patients with Kellgren–Lawrence grade IV varus KOA and two healthy subjects were enrolled in this study. Both patients underwent unilateral TKA. FEA models were established based on CT and MR images of the knees of the patients with KOA and healthy subjects. Gait analysis was performed using a three‐dimensional motion capture system with a force plate. Three direction forces at the ankle joints were calculated by inverse dynamic analysis, which provided the load for the FEA models. The total contact forces of the knee joints were also calculated by inverse dynamic analysis to enable comparisons with the results from the FEA models. The total knee contact forces, maximum von Mises stress, and stress distribution of the medial plateau were compared between the patients and healthy subjects. The distributions of the medial plateau force at 2 and 6 months postoperatively were compared with the distributions of the forces preoperatively and those in the healthy subjects. Results During static standing, the medial plateau bore the most of the total contact forces in the knees with varus KOA (90.78% for patient 1 and 93.53% for patient 2) compared with 64.75 ± 3.34% of the total force in the healthy knees. At the first and second peaks of the ground reaction force during the stance phase of a gait cycle, the medial plateau bore a much higher percentage of contact forces in patients with KOA (74.78% and 86.48%, respectively, for patient 1; 70.68% and 83.56%, respectively, for patient 2) than healthy subjects (61.06% ± 3.43% at the first peak and 72.09% ± 1.83% at the second peak). Two months after TKA, the percentages of contact forces on the medial tibial plateau were 79.65%–85.19% at the first and second peaks of ground reaction forces during the stance phase of a gait cycle, and the percentages decreased to 53.99% – 68.13% 6 months after TKA. Conclusion FEA showed that TKA effectively restored the distribution of tibio‐femoral contact forces during static standing and walking, especially 6 months after the surgery. The changes in the gait were consistent with the changes in the contact force distribution calculated by the FEA model.

Three-Dimensional Motion Analysis After TKA: The Effect of PCL Resection

Total Knee Replacement for Posttraumatic Degenerative Arthritis of the Knee.

In Vivo Function of Posterior Cruciate Ligament Before and after Posterior Cruciate Ligament-Retaining Total Knee Arthroplasty

IN VIVO THREE-DIMENSIONAL KINEMATICS OF TOTAL KNEE REPLACEMENTS DURING OPEN AND CLOSED KINETIC CHAIN ACTIVITIES

Biomechanical role of posterior cruciate ligament in total knee arthroplasty: A finite element analysis

Adjusting Insert Thickness and Tibial Slope Do Not Correct Internal Tibial Rotation Loss Caused by PCL Resection: In Vitro Study of a Medial Constraint TKA Implanted with Unrestricted Calipered Kinematic Alignment

Intraoperative knee kinematics measured by computer‐assisted navigation and intraoperative ligament balance have the potential to predict postoperative knee kinematics

Anterior Position of the Femoral Condyle During Mid-Flexion Worsens Knee Activity After Cruciate-Retaining Total Knee Arthroplasty

Partial restoration of knee kinematics in severe valgus deformity using the medial-pivot total knee arthroplasty

Articular contact kinematics of the knee before and after a cruciate retaining total knee arthroplasty.

Kinematic And Kinetic Analysis Of Lower Limb Before And After Total Knee Arthroplasty (Tka) In A Chinese Population

Altered knee kinematics after posterior cruciate single-bundle reconstruction—a comprehensive prospective biomechanical in vivo analysis

Weight-bearing Condyle Motion of the Knee Before and after Cruciate-Retaining TKA: In-vivo Surgical Transepicondylar Axis and Geometric Center Axis Analyses

Kinematic analysis of stair climbing in rotating platform cruciate-retaining and posterior-stabilized mobile-bearing total knee arthroplasties

Three-dimensional gait characteristics of patients after unilateral total knee arthroplasty

Effect of Posterior Cruciate Ligament Resection on Gap Balancing in Robot‐assisted Total Knee Arthroplasty

Effect of single-radius design on in vivo kinematics during stair activities after total knee arthroplasty

Effect of Joint Line Elevation after Posterior-stabilized and Cruciate-retaining Total Knee Arthroplasty on Clinical Function and Kinematics

Tibio‐Femoral Contact Force Distribution of Knee Before and After Total Knee Arthroplasty: Combined Finite Element and Gait Analysis

Mobile medial pivot (lateral slide)‐type total knee arthroplasty exhibited different motion patterns between under anaesthesia and weight‐bearing condition

Load-Dependent Characteristics of Cruciate-Retaining and Posterior-Stabilized Total Knee Arthroplasty: A Biomechanical Study