Abstract:Huge and critical structures, such as fuel storage tanks and nuclear power plants, are often built on dense sandy grounds, which may cause excessive plastic deformations under multidirectional cyclic shearing conditions caused by earthquakes. The lack of investigation of sand behavior under multidirectional loading may lead to unsafe designs, and thus significantly increase the maintenance cost for infrastructures during their long operational time, which might be longer than 100 years. This study presents a numerical investigation on the liquefaction behavior of dense sand under bidirectional cyclic simple shear using the discrete element method. The bidirectional cyclic simple shear tests with varying stress trajectories on the deviatoric stress plane, including figure-8, circular, and straight lines, were conducted. Additionally, a series of unidirectional loading tests was conducted in the simulation scheme for comparison purposes. The effect of the initial static shear on the cyclic behavior and liquefaction resistance of granular materials was examined. Four loading categories, including full reversal, partial reversal, intermediate reversal, and no reversal, were implemented in the numerical simulations. Although the presence of the initial static shear may enhance the cyclic resistance of granular samples under unidirectional loading, it mitigates the liquefaction resistance and promotes the failure of specimens under bidirectional shearing conditions. The microscopic analysis was performed to reveal the relationship between the fabric evolution and external loading, which can provide profound insights into the underlying mechanism of the cyclic behavior and liquefaction susceptibility of granular material when both the bidirectional shearing and initial static shear effects are considered.

Cyclic volumetric strain accumulation for sand under drained simple shear condition

Advanced laboratory investigation of axial cyclic loading in silica sands

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Effects of Initial Static Shear on Cyclic Resistance and Pore Pressure Generation of Saturated Sand

Undrained Behavior of Sand under Cyclic Paths That Match Storm-Wave Loading Conditions

Undrained Cyclic Behavior of Granular Materials Considering Initial Static Shear Effect: Insights from Discrete Element Modeling

Discrete-Element Simulation of Dense Sand under Uni- and Bidirectional Cyclic Simple Shear Considering Initial Static Shear Effect

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Energy-Based Approach to Quantify Cyclic Resistance and Pore Pressure Generation in Anisotropically Consolidated Sand

Flow Deformation and Cyclic Resistance of Saturated Loose Sand Considering Initial Static Shear Effect

Soil-pile interaction on an instrumented pile under cyclic axial loads in sand

Cyclic accumulative deformation of sand and its explicit model

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Effect of Drained Static Shear on Cyclic Deformation Behavior of K-0-consolidated Sand

Estimating normal effective stress degradation in sand under undrained simple shear condition

Liquefaction of Sand under Monotonic and Cyclic Shear Conditions: Impact of Drained Preloading History

Permanent Deformation Characteristics of Saturated Sand under Cyclic Loading

Pore pressure and strain development of Wenzhou saturated soft soil under cyclic loading by stages

Stress-strain Response of Saturated Sand During Cyclic Water Absorption Shearing

The effects of changing the deviatoric and spherical stresses during cyclic loading on the drained response of a sand