Abstract:This work presents our recent research and development of environment-friendly MEMS fabrication technology based on an eco-friendly silicon deep reactive ion etching (D-RIE), and polymer-MEMS utilizing hot embossing process. In order to show the capability of this ‘Green’ fabrication technology, several typical MEMS devices have been fabricated successfully. Regarding silicon dry etching technology, the often-used gas SF6 which has very high Global Warming Potentials (GWP) should be replaced by other lower GWP gases, such as Ar/F2. First, the gases were selected with consideration of the simple handle and less danger. Then, Si etching experiments corresponding to these gases were performed and analyzed systematically to find out the most suitable process which can reduce or replace SF6 gas. Furthermore, the etching rate improvement was also studied based on process’s real-time monitoring and feed-back control technology to optimize the timing of deposition and etching steps (Bosch process); therefore, bias RF power can be smartly controlled during the process. In polymer-MEMS technology, we have developed a novel fabrication of a monolithic PMMA MEMS devices utilizing hot embossing, surface-activated direct bonding, polishing, and elliptical vibration cutting processes. The robustness and capability of the method are demonstrated through the fabrication of sophisticated PMMA freestanding micro structures and devices. An efficient technique using reinforcement material to protect the PMMA microstructures during release process was proposed. Small Young’s modulus and high thermal expansion of polymer are the advantages for electrostatic and thermal actuators, respectively, because it will require less power than silicon counterparts to produce the same displacement. All PMMA acceleration sensor, actuators and mirror device have been fabricated to shows the advantages of polymer-MEMS technology. Fig. 1 shows typical MEMS devices made of PMMA polymer by using our polymer-MEMS fabrication process.

Plasma‐Based Additive Manufacturing Method for MEMS Using APSLD (Atmospheric Pressure Sputtering Layer Deposition) Technology

PowderMEMS—A Generic Microfabrication Technology for Integrated Three-Dimensional Functional Microstructures

Advanced plasma processing combined with trench isolation technology for fabrication and fast prototyping of high aspect ratio MEMS in standard silicon wafers

Additive manufacturing of three-dimensional (3D) microfluidic-based microelectromechanical systems (MEMS) for acoustofluidic applications

Atmospheric Pressure Plasma Functionalization of Sealed PDMS Microfluidics: Application to Capillary Pumping and Enhanced Cell Growth.

Additive Manufacturing of Micro-Electro-Mechanical Systems (MEMS)

Additive Manufacturing of Liquid/Gas Diffusion Layers for Low-Cost and High-Efficiency Hydrogen Production

Laser‐Activated Selective Electroless Plating on 3D Structures via Additive Manufacturing for Customized Electronics

In situ jet electrolyte micromachining and additive manufacturing

Using the Spark Plasma Sintering System for Fabrication of Advanced Semiconductor Materials

Hybrid Additive and Subtractive Manufacturing Method Using Pulsed Arc Plasma

Integration of Mechatronic Functions on Additively Manufactured Components via Laser‐Assisted Selective Metal Deposition

Aerosol based direct-write micro-additive fabrication method for sub-mm 3D metal-dielectric structures

Development of Additive Manufacturing Method by Selective Melting Using Micro Arc Plasma

Environment Friendly MEMS Process

Laminated Photoresist Sacrificial Layer Process for 3-D Movable Suspension Microstructures in LIGA-Based Surface Micromachining

Fabrication of polyetheretherketone (PEEK)-based 3D electronics with fine resolution by a hydrophobic treatment assisted hybrid additive manufacturing method

3D Printed MEMS Technology—Recent Developments and Applications

An Integrative 3D printing method for rapid additive manufacturing of a capacitive force sensor

Rapid surface preparation for three-dimensional characterization of defect and microstructure of metal additive manufacturing using electrochemical jet

Powder sheet additive manufacturing of multi-material structures: Experimental and computational characterizations