Assessment of erosion wear in low specific speed Francis turbine due to particulate flow

Shubham Sharma,Bhupendra K. Gandhi

DOI: https://doi.org/10.1016/j.apt.2023.104065

IF: 4.969

2023-09-01

Advanced Powder Technology

Abstract:The erosion wear of turbine components reduces the turbine life and consequently decreases the efficiency or power generation. In the present work, the effect and cause of erosion wear in a high head Francis turbine are investigated through the measurements and numerical simulations on a prototype turbine. Localised erosion patterns are observed over the surface of the guide vane, runner, faceplate, and labyrinth seal due to existing particulate flows. Further, the physical interpretation of erosion wear mechanisms is studied through numerical simulations, and the eroded zones of different components are qualitatively validated with the actual site in-situ measurements. The erosion rate prediction of the turbine components is performed by employing a recently developed erosion model for CA6NM turbine material. The results show that the continuous interblade vortex with significant velocity and crossflow between the blade passages is found accountable for the severe erosion of the runner shroud. The dominating effect of flow instability at the off-design operation depicts higher erosion of turbine components. Moreover, the exponent value for the particle size is found to vary in the range of 1.16–1.30 for the material removal rate of turbine components.

engineering, chemical