Abstract:Abstract The average measured sediment concentration of the river section where Wanjiazhai Hydropower Station is located over the years is 5.7kg/m 3, The maximum measured sediment concentration reaches 37.6kg/m 3, The erosion of the flow components of hydraulic turbines caused by sand containing water flow is becoming increasingly severe, coupled with the frequent impact of load changes during peak shaving operation, the problems exposed during the operation of hydraulic turbines are becoming more prominent, which affects the stable operation of the units. This article uses numerical simulation and experimental testing to study the sediment wear characteristics and hydraulic performance of the water turbine at Wanjiazhai Hydropower Station. Research has revealed the effects of working head on impeller wear. The increase in working head will exacerbate the impact wear on the main channel wall of the unit. The surface of water turbine blades is the main wear area, and the high-speed impact of particles causes an increase in the wall wear rate. The probability of particles coming into contact with the wall at the outlet increases, resulting in rapid wear at this point. The increase in head will intensify the wear intensity of the unit surface, and the flow velocity in the gap indicates that the local high-speed jet in the gap is the main cause of gap wear. Therefore, in order to ensure the efficient anti-wear performance of the water turbine, multiple factors need to be comprehensively considered to cope with sediment wear of the water turbine, including regular cleaning, optimized structural design, use of wear-resistant materials, replacement of worn parts, and optimization of operating parameters. These measures help to reduce the damage of sediment wear to water turbines and extend their service life.

Erosion Wear on the Runner Shroud of a Francis Turbine

Erosion Wear on Runner of Francis Turbine in Jhimruk Hydroelectric Center

Assessment of erosion wear in low specific speed Francis turbine due to particulate flow

Numerical study on sediment erosion characteristics of Francis turbine runner

Experimental study of sediment erosion in Francis runner using a non-recirculating test rig

Effects of Particle Erosion on the Submersible Pump in an Ultra-High Voltage Transformer

Numerical Investigation of the Erosion Behavior in Blades of Tidal Current Turbine

A study of sediment erosion of runner seal of a Francis turbine

Numerical Prediction of Erosion of Francis Turbine in Sediment-Laden Flow under Different Heads

Investigation of sediment erosion phenomenon for different blade angle distribution in Francis runner

Effect of the leakage flow through guide vanes on the erosion pattern and performance of Francis runner

CFD Analysis on Francis Turbine to Analyse Erosion Wear Due to Sediment Flow

Numerical prediction of erosion of Francis turbine in sediment laden flow

Study On The Wearing Law Of The Runner And Guide Vanes For A Francis Turbine

Study on sediment erosion of high head Francis turbine runner in Minjiang River basin

Design and Verification of Francis Turbine Working in Sand Laden Hydro-Power Plant

Study on the Influence of Sediment Erosion of Francis Turbine Runner under Different Water Heads

Prediction of sediment wear of francis turbine with high head and high sediment content

Experimental Erosion Flow Pattern Study of Pelton Runner Buckets Using a Non-Recirculating Test Rig

Sediment erosion in the labyrinths of Francis turbine: A numerical study

Prediction for the Influence of Guide Vane Opening on the Radial Clearance Sediment Erosion of Runner in a Francis Turbine