Abstract:The role of hydropower as a renewable energy source is well understood. However, due to the geological characteristics of certain regions, hydropower systems there are facing a unique challenge of excessive sedimentation in rivers. A significant number of research works were performed in the past, which focused on the effects of sediments on the turbine components, that includes reduction in efficiency of the turbine and increase in the erosion wear. Experimental studies of erosion in laboratory conditions are usually limited by several characteristics that affect erosion and complications of handling sediments. As a result, these investigations are normally carried out in a simplified apparatus. This study focuses on using a non-recirculating type of sediment erosion test rig, where a model of Francis turbine is used for experimental investigations. Previous studies have shown that in the case of Francis turbines, erosion occurs in the clearance gap of guide vanes, which increases the size of the gap. The flow from the pressure side of the guide vane is driven into the suction side due to the pressure difference between the two sides. This leakage flow ultimately develops into a vortex filament and hits the runner blades towards the hub and shroud. In this study, the erosion pattern of the runner blades towards these locations are studied by using color coatings. A clearance gap of 4 mm has been created in the guide vane and the consequent impact on the erosion and efficiency of the turbine are studied. The objective is to isolate the effects of leakage flow on erosion in the runner inlet, as well as the overall performance of the Francis turbine. The effect has been observed in terms of increased flow rate, decreased efficiency and erosion in the leading edge of the runner.

CFD Analysis on Francis Turbine to Analyse Erosion Wear Due to Sediment Flow

Assessment of erosion wear in low specific speed Francis turbine due to particulate flow

Numerical Analysis of Erosive Wear on the Guide Vanes of a Francis Turbine

Investigation of sediment erosion phenomenon for different blade angle distribution in Francis runner

Experimental study of sediment erosion in Francis runner using a non-recirculating test rig

Study On The Wearing Law Of The Runner And Guide Vanes For A Francis Turbine

Numerical prediction of erosion of Francis turbine in sediment laden flow

Numerical Investigation of the Erosion Behavior in Blades of Tidal Current Turbine

Prediction of sediment wear of francis turbine with high head and high sediment content

Erosion Wear on the Runner Shroud of a Francis Turbine

Numerical study on sediment erosion characteristics of Francis turbine runner

Numerical Simulation of Flow Fields and Sediment-Induced Wear in the Francis Turbine

Numerical Prediction of Sediment Erosion on Francis Turbine Blades

Prediction for the Influence of Guide Vane Opening on the Radial Clearance Sediment Erosion of Runner in a Francis Turbine

Numerical Prediction of Erosion of Francis Turbine in Sediment-Laden Flow under Different Heads

Numerical Analysis of Francis Turbine being operated in variable speed from sediment erosion perspective

A study of sediment erosion of runner seal of a Francis turbine

Comparative Evaluation of Sand Erosion in Reversible Turbine at Pump Mode and Turbine Mode

Effect of the leakage flow through guide vanes on the erosion pattern and performance of Francis runner

Sediment erosion in the labyrinths of Francis turbine: A numerical study

Design and Verification of Francis Turbine Working in Sand Laden Hydro-Power Plant