Abstract:During the production of fiber-reinforced plastics using resin transfer molding (RTM), various characteristic defects and flaws can occur, such as fiber displacement and fiber waviness. Particularly in high-pressure RTM (HP-RTM), fiber misalignments are generated during infiltration by local peaks in the flow rate, leading to a significant reduction in the mechanical properties. To minimize or avoid this effect, the manufacturing process must be well controlled. Simulative approaches allow for a basic design of the mold filling process; however, due to the high number of influencing variables, the real behavior cannot be exactly reproduced. The focus of this work is on flow front monitoring in an HP-RTM mold using phased array ultrasonic testing. By using an established non-destructive testing instrument, the effort required for integration into the manufacturing process can be significantly reduced. For this purpose, investigations were carried out during the production of test specimens composed of glass fiber-reinforced polyurethane resin. Specifically, a phased array ultrasonic probe was used to record individual line scans over the form filling time. Taking into account the specifications of the probe used in these experiments, an area of 48.45 mm was inspected with a spatial resolution of 0.85 mm derived from the pitch. Due to the aperture that had to be applied to improve the signal-to-noise ratio, an averaging of the measured values similar to a moving average over a window of 6.8 mm had to be considered. By varying the orientation of the phased array probe and therefore the orientation of the line scans, it is possible to determine the local flow velocities of the matrix system during mold filling. Furthermore, process simulation studies with locally varying fiber volume contents were carried out. Despite the locally limited measuring range of the monitoring method presented, conclusions about the global flow behavior in a large mold can be drawn by comparing the experimentally determined results with the process simulation studies. The agreement between the measurement and simulation was thus improved by around 70%.

RESIN FLOW ANALYSIS DURING FABRICATION OF COCONUT MESOCARP FIBER-REINFORCED COMPOSITES USING VARTM PROCESS

Novel approach for mold filling simulation of the processing of natural fiber reinforced composites by resin transfer molding

An Enhanced Vacuum-Assisted Resin Transfer Molding Process and Its Pressure Effect on Resin Infusion Behavior and Composite Material Performance

Application of calcium carbonate in resin transfer molding process: An experimental investigation

Resin Film Infusion Process: Numerical Algorithm

An approach to couple mold design and on-line control to manufacture complex composite parts by resin transfer molding

Simulation of Reinforced Reactive Injection Molding with the Finite Volume Method

Flow Characteristics of Basalt Fiber Reinforced Composite Processed by Liquid Resin Infusion on Temperature

Numerical Simulation of Two-Phase Flow in Liquid Composite Moulding Using VOF-Based Implicit Time-Stepping Scheme

Modeling Approach for Reactive Injection Molding of Polydisperse Suspensions with Recycled Thermoset Composites

Resin Impregnation During the Manufacturing of Composite Materials Subject to Prescribed Injection Rate

A 2D modeling approach for fluid propagation during FE-forming simulation of continuously reinforced composites in wet compression moulding

Simulation method for filling stage in liquid composite molding based on a two-phase flow volume of fluid model

A Review of Non-saturated Resin Flow in Liquid Composite Moulding processes

Optimization of the cycle time in resin transfer molding process by numerical simulation

Investigation on the tensile and flexural behavior of coconut inflorescence fiber reinforced unsaturated polyester resin composites

Injection molding simulation of short fiber reinforced thermosets with anisotropic and non-Newtonian flow behavior

Thermal Behaviors of the Resin and Mold in the Process of Resin Transfer Molding

Sensor Fusion for Simultaneous Estimation of In-Plane Permeability and Porosity of Fiber Reinforcement in Resin Transfer Molding

Analysis of Upper- and Lower-Limits of Fill Time in Resin Transfer Mold Filling Simulation

Flow Front Monitoring in High-Pressure Resin Transfer Molding Using Phased Array Ultrasonic Testing to Optimize Mold Filling Simulations