Abstract:Purpose The purpose of this paper is to develop thermal modelling to investigate the thermal response of sample boards (at board level) during the preheating stage of the reflow process and to validate with experimental measurements. Design/methodology/approach A thermal‐coupling method that adopted the Multi‐physics Code Coupling Interface (MpCCI) was utilized. A forced‐convection reflow oven was modelled using computational fluid dynamic software ( FLUENT 6.3.26 ), whereas structural heating at the board level was conducted using finite‐element method software ( ABAQUS 6.9 ). Findings The simulation showed a complex flow pattern having characteristics of a free‐jet region, stagnation‐flow region, wall jet‐region, recirculation region and vortices. A sharp maximum heat‐transfer coefficient was detected in the stagnation region of the jet, resulting in a spatial variation of local heat transfer on a thermal profile board (TPB). This coefficient affected the temperature distribution in the TPB with different specific heat capacitances and thermal conductivity of the structure. The simulation results were in good agreement with the experimental data and analytical model. The cold region and temperature uniformity (ΔT) increased with increasing complexity of the TPB. The cold region can occur in two possible locations in the TPB. Both occurrences can be related to the flow field of the reflow oven. ΔT of the TPB decreased when the conveyor speed (v) was reduced. A suitable conveyor speed (1.0 cm/s) was determined to maintain ΔT below 10°C, which prevented the thermally critical package from overheating. Practical implications The paper provies a methodology for designing a thermal profile for reflow soldering production. Originality/value The findings provide fundamental guidelines to the thermal‐coupling method at the board and package levels, very useful for accurate control of ΔT at the board and package levels, one of the major requirements in achieving a high degree of reliability for electronic assemblies.

Investigations of Infrared Desktop Reflow Oven with FPCB Substrate during Reflow Soldering Process

Investigations of Infrared Desktop Reflow Oven with FPCB Substrate during Reflow Soldering Process

Experimental and numerical investigation of 3D gas flow temperature field in infrared heating reflow oven with circulating fan

Temperature Prediction on Flexible Printed Circuit Board in Reflow Oven Soldering for Motherboard Application

Three‐dimensional thermal investigations at board level in a reflow oven using thermal‐coupling method

CFD modelling of the flow field inside a reflow oven

A Reflow Soldering Retro-Design System for Rework Station Based on Q-factor

Temperature Modeling of Reflow Soldering Based on the Heat Transfer Mechanisms

An intelligent system for reflow oven temperature settings based on hybrid physics-machine learning model

Development of low-cost reflow oven for SMT assembly

Smarter Temperature Setup for Reflow Oven to Minimize Temperature Variation Among Components

Evaluation of Nonintrusive Active Infrared Thermography Technique to Detect Hidden Solder Ball Defects on Plastic Ball Grid Array Components

Determination of Smarter Reflow Profile to Achieve a Uniform Temperature Throughout a Board

Integrated Approach to Obtain Gas Flow Velocity in Convection Reflow Soldering Oven

A Novel On-board Temperature Monitoring Approach in the Reflow Soldering Process

Numerical investigations on the effects of different cooling periods in reflow-soldering process

Temperature Curve of Reflow Furnace Based on Newton's Law of Cooling

Optimization Method for Hot Air Reflow Soldering Process Based on Robust Design

Thermal profiling: a reflow process based on the heating factor