Abstract:Low-temperature selective catalytic reduction (SCR) is an economical and feasible technology to effectively reduce NOx emissions from combustion sources. However, low-temperature SCR still suffers from low activity and SO2/H2O poisoning of catalysts. Here, a strategy to promote SCR activity and anti-poisoning ability was proposed through enhancing the metal–metal interaction. Ternary ferrite spinel material (CuMnFeO4) with a stronger metal–metal interaction was synthesized through incorporating Mn cations into the tetrahedral sites of CuFe2O4 spinel. CuMnFeO4 spinel mainly exists in an amorphous form and shows good SCR performance and SO2/H2O anti-poisoning ability in the temperature window of 200–350 °C. Density functional theory calculations were used to investigate the atomic-level reaction mechanism of NO reduction. Theoretical results indicate that NO and NH3 adsorptions over the CuMnFeO4 catalyst are controlled by the chemisorption mechanism. The interaction between reactants (NO and NH3) and the CuMnFeO4 surface is closely associated with the orbital hybridization of N and Fe atoms. The SCR reaction of NO with NH3 over the CuMnFeO4 catalyst is governed by a six-step process (NO → NO* → H2NNO* → HNHNO* → HNNOH* → N2* → N2), in which the first H-transfer reaction (H2NNO* → HNHNO*) presents the highest activation energy barrier of 230.84 kJ/mol and is the rate-determining step of the NH3-SCR reaction. Finally, a SCR cycle reaction scheme was proposed to understand the reaction process of NO reduction over CuMnFeO4 spinel.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.energyfuels.0c02293?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.energyfuels.0c02293</a>.BET surface area and average pore diameter of different catalysts (Table S1), schematic diagram of the experimental system for NO reduction (Figure S1), and crystal structure of CuMnFeO4 spinel, octahedral Cu2+ cation, tetrahedral Mn3+ cation, octahedral Fe3+ cation, and CuMnFeO4(100) surface (Figure S2) (<a class="ext-link" href="/doi/suppl/10.1021/acs.energyfuels.0c02293/suppl_file/ef0c02293_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Electroplating sludge-derived spinel catalysts for NO removal via NH3 selective catalysis reduction

Tailoring the Proceeding of the NH3-SCO and NH3-SCR Reactions over FeOx Catalysts by Modifying with NbOx

Metal–Metal Interactions of Ternary Spinel for Efficient NH 3 Selective Catalytic Reduction of NO x at a Low Temperature

Synthesis of electrocatalyst from electroplating sludge for efficient N2 reduction under ambient conditions

A novel high activity MnXFe3−XO4 spinel catalyst for selective catalytic reduction of NO using NH3 prepared by a short process from natural minerals for low-temperature sintering flue gas: Effect of X value on catalytic mechanism

Sludge Recycling from Non-Lime Purification of Electrolysis Wastewater: Bridge from Contaminant Removal to Waste-Derived NOX SCR Catalyst

Structure and activity relationships of AMn2O4 (A = Mg and Zn) spinels in selective catalytic reduction of NOx with NH3

Heteroatoms doped iron oxide-based catalyst prepared from zinc slag for efficient selective catalytic reduction of NOx with NH3

Structural Effects of Iron Spinel Oxides Doped with Mn, Co, Ni and Zn on Selective Catalytic Reduction of NO with NH3

Catalytic reduction of nitrogen monoxide using iron–nickel oxygen carriers derived from electroplating sludge: Novel method for the collaborative emission decrease of polluting gases

Modified cold-rolled sludge as catalyst for selective catalytic reduction of NOx with NH3 at low temperatures

CrO3 Supported on Sargassum-Based Activated Carbon As Low Temperature Catalysts for the Selective Catalytic Reduction of NO with NH3

Structure–Activity Relationships of AMn2O4 (A = Cu and Co) Spinels in Selective Catalytic Reduction of NOx: Experimental and Theoretical Study

Low-Cost CuX Catalyst from Blast Furnace Slag Waste for Low-Temperature NH 3 -SCR: Nature of Cu Active Sites and Influence of SO 2 /H 2 O

Strong metal oxide-zeolite interactions during selective catalytic reduction of nitrogen oxides

Optimization of isolated copper species on the NH 3 -SCR performance over Cu/SSZ-39 modified by ammonia water

Transformation of waste battery cathode material LiMn2O4 into efficient ultra-low temperature NH3-SCR catalyst: Proton exchange synergistic vanadium modification

Selective Catalytic Reduction of NO over Mo/ZSM-5 Catalyst

Improvement of the Activity of Γ-Fe2o3 for the Selective Catalytic Reduction of NO with NH3 at High Temperatures: NO Reduction Versus NH3 Oxidization

Low-cost Co–Al spinel and M–Co–Al (M = Fe and Ce) catalysts for selective catalytic reduction of NOx with NH3

Alkali poisoning of Fe-Cu-ZSM-5 catalyst for the selective catalytic reduction of NO with NH3