Abstract:Abstract Fiber-optic cables cemented outside of the casing of an unconventional well measure cross-well strain changes during fracturing of neighboring wells with low-frequency distributed acoustic sensing (LF-DAS). As a hydraulic fracture intersects an observation well instrumented with fiber-optic cables, fracture fluid injected at ambient temperatures can cool a section of the sensing fiber. Often, LF-DAS and distributed temperature sensing (DTS) cables are run in tandem, enabling the detection of such cooling events. The increasing use of LF-DAS for characterizing unconventional hydraulic fracture completions demands an investigation of the effects of temperature on the measured strain response by LF-DAS. Researchers have demonstrated that LF-DAS can be used to extract the temporal derivative of temperature for use as a differential-temperature-gradient sensor. However, differential-temperature-gradient sensing is predicated on the ability to filter strain components out of the optical signal. In this work, beginning with an equation for optical phase shift of LF-DAS signals, a model relating strain, temperature, and optical phase shift is explicitly developed. The formula provides insights into the relative strength of strain and temperature effects on the phase shift. The uncertainty in the strain-rate measurements due to thermal effects is estimated. The relationship can also be used to quantify uncertainties in differential-temperature-gradient sensors due to strain perturbations. Additionally, a workflow is presented to simulate the LF-DAS response accounting for both strain and temperature effects. Hydraulic fracture geometries are generated with a 3D fracture simulator for a multi-stage unconventional completion. The fracture width distributions are imported by a displacement discontinuity method program to compute the strain-rates along an observation well. An analytic model is used to approximate the temperature in the fracture. Using the derived formulae for optical phase shift, the model outputs are then used to compute the LF-DAS response at a fiber-optic cable, enabling the generation of waterfall plots including both strain and thermal effects. The model results suggest that before, during, and immediately following a fracture intersecting a well instrumented with fiber, the strain on the fiber drives the LF-DAS signal. However, at later times, as completion fluid cools the observation well, the temperature component of the LF-DAS signal can equal or exceed the strain component. The modeled results are compared to a published field case in an attempt to enhance interpretation of LF-DAS waterfall plots. Finally, we propose a sensing configuration in order to identify the events when "wet fractures" (fractures with fluids) intersect the observation well.

Pressure and thermal effects on Rayleigh fiber-optic strain measurment for soil-structure interaction

Quantitative Evaluation of Optical Fiber/Soil Interfacial Behavior and Its Implications for Sensing Fiber Selection

Interfacial characterization of soil-embedded optical fiber for ground deformation measurement

Advanced Fiber Optic Sensing for Cryogenic Simultaneous Temperature and Strain Measurement

A Novel Method of Embedding Distributed Optical Fiber Sensors for Structural Health Monitoring

Monitoring Flexure Behavior of Compacted Clay Beam Using High-Resolution Distributed Fiber Optic Strain Sensors

Experimental Research on Strain Transfer Behavior of Fiber-Optic Cable Embedded in Soil Using Distributed Strain Sensing

Experimental Study of Measuring Strain by Fiber-Optic Sensor Used in Civil Engineering Structures

Role of the interface between distributed fibre optic strain sensor and soil in ground deformation measurement

Distributed polymer optical fiber sensors using digital I-OFDR for geotechnical infrastructure health monitoring

Quantifying Progressive Failure of Micro-Anchored Fiber Optic Cable–Sand Interface via High-Resolution Distributed Strain Sensing

Application of Distributed Optical Fiber Strain Measurement into Geotechnical Engineering Monitoring

Drying-induced soil shrinkage and desiccation cracking monitoring with distributed optical fiber sensing technique

Feasibility Study of Anchored Fiber-Optic Strain-Sensing Arrays for Monitoring Soil Deformation Beneath Model Foundation

The Application of High-Resolution, Embedded Fibre Optic (FO) Sensing for Large-Diameter Composite Steel/Plastic Pipeline Performance under Dynamic Transport Loads

Characterizing the strain transfer on the sensing cable-soil interface based on triaxial testing

Thermal Effects on Far-Field Distributed Acoustic Strain-Rate Sensors

Performance Evaluation of Soil-Embedded Plastic Optical Fiber Sensors for Geotechnical Monitoring

A review of previous studies on the applications of optical fiber sensors in geotechnical health monitoring

Study of Large Strain OFDR Sensor Based on Inclined Transfer Structure

The stability of optical fiber as strain sensor under invariable stress